Ge 15274 Plug-In GE Strip Timer Manuel d'utilisateur télécharger pdf

POWER SAVING STRIP TIMER

8 Outlet Power Strip - 24-Hour Programmable Function with 4 Outlets

Based On Timer and 4 Outlets Based On Switch Function

RATINGS

125 V / 15 A / 1875 W

14/3 AWG SJT Vinyl Power Cord

TIMER OPERATING INSTRUCTIONS

Made in China 07/09

POWER STRIP:

This eight outlet tap is rated at 15 amps total. Combined

load must not exceed 15 amps or 1875 watts. Use only

in dry indoor locations. Not for use with aquariums. The

15 amp 125 volt AC 8-outlet strip plugs into any 3-wire

grounding wall outlet and provides eight outlets that will

accept either 2-blade non-grounding plugs or 3-blade

grounding. The handy, built-inmaster switch/circuit

breaker allows you to turn power to all outlets ON or OFF,

and will interrupt power in case of an overload condition

(when outlets are set to be powered).

NOTE: This device is not a surge suppressor and will not

afford protection in the event of power surges.

INSTRUCTIONS:

When the device is plugged in and the master switch is

on, the timer’s dial will turn clockwise. The arrowhead on

the face of the timer points to the current time of day.

1. Locate the segments on the edge of the timer’s dial.

Each of these segments equals 15 minutes. For easy

setting, use a pen or pencil to pull the segments up. To

select the hours you want the ﬁxture turned ON, push

down the segments within these hours on the dial. For

example, to have the timer turn on a ﬁxture between

6 PM and 8 PM and then again between 10 PM and 2

AM, push down all the segments between 6 PM and 8

PM, and between 10 PM and 2AM on the timer’s dial.

2. Rotate the timer’s dial clockwise until the arrowhead

on the face points to the current time of day. Note: AM

and PM are marked on the dial.

3. Set the timer switch at the side of power strip to the

TIMER ON position.

4. Plug the power strip into an electrical outlet conve-

nient to the ﬁxture to be controlled.

5. Plug the ﬁxture into a timed outlet. Turn the ﬁxture’s

switch ON for automatic control. The timer will not

turn the ﬁxture on if the ﬁxture’s switch and/or power

strip switch is OFF. The ﬁxture will now turn on and off

at the times you have set.

NOTE: To override the timer and use your ﬁxture normal-

ly, set the timer switch to the OUTLET ON position. This

will deactivate the timer’s control of the ﬁxture, but the

timer’s dial will still show the current time of day.

To reactivate the timer’s control of the ﬁxture, turn the

ﬁxture’s switch ON and set the timer’s switch to TIMER

ON. In case of power failure, or after turning on the

master switch, reset the time of day as explained in

step 2.

Résumé du contenu

Page 1 - INSTRUCTIONS:

POWER SAVING STRIP TIMER 8 Outlet Power Strip - 24-Hour Programmable Function with 4 Outlets Based On Timer and 4 Outlets Based On Switch FunctionRAT

Commentaires sur ces manuels

Pas de commentaire

Ge 15274 Plug-In GE Strip Timer Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Horloge Ge 15274 Plug-In GE Strip Timer. GE 15274 Plug-In GE Strip Timer User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Horloge Ge 15274 Plug-In GE Strip Timer