Ge 15279 In-Wall Spring Wound Timer Manuel d'utilisateur télécharger pdf

CAUTION:

Installation by a licensed electrician is recommended. Installation and use of this equipment should be in accordance with provisions of the U.S. National

Electrical Code, applicable local codes and pertinent industry standards.

These timers are not to be used in precision timing applications when inaccurate timing could have dangerous consequences such as with sun lamps or in

tanning booths.

Do not use to control receptacles.

For indoor use only unless installed in a, NEMA type 3R enclosure.

Use only copper wire.

Speciﬁcations:

20A, 125VAC General Purpose

10A, 250VAC General Purpose

10A, 277VAC General Purpose

7A, 125VAC Tungsten

1HP, 125VAC

1HP, 250VAC

Installation Instructions

This GE Spring Wound Timer is easy to install and will ﬁt in any standard 2-1/2 inch deep wall box. Timer ﬁts both toggle switch and rocker/decorator switch

applications in a single or multi gang vertically installed box setup. Timer will work in single pole, 3-Way, or reverse acting applications. If you are unsure about

the installation of this timer please contact a licensed electrician.

1. Turn power off at circuit breaker or fuse box before installation.

2. Remove current wall plate and current switch from vertically installed wall box.

3. Wires should be stripped 5/16 inch long. Wire Strip gauge on back of timer may be used to measure 5/16 inch.

4. Attach wires to timer by sliding the stripped end of the wires into the timer terminals. Be sure and note the proper wiring for your particular application. See

“Applications” section of this manual for more information. Screw terminals down tight to secure the wires to the timer. (See Image Below)

5. Attach ground wire (green) to bare ground in wire box. Use included wire nut and twist together see image of typical SPST installation.

Typical SPST Installation

* Note – Ground and Neutral are not used by the timer.

6. Insert timer into the 2-1/2” wall box being careful not to pinch any wires. Be sure the TOP (indicated on front of timer) is facing up. Fasten the timer to the

wall box using the screws provided.

7. Place provided metal wall plate on timer referring to the appropriate diagram below.

INSTRUCTIONS

WALL BOX TIME SWITCH

15279