Ge Plug-In 15090 GE Strip Timer Manuel d'utilisateur télécharger pdf

POWER SAVING STRIP TIMER

8 Outlet Power Strip - 24-Hour Programmable Function

with 4 Timed Outlets

RATINGS

125VAC 15A 60Hz

125VAC 1000W Tungsten

125VAC 1/3 HP

TIMER OPERATING INSTRUCTIONS

POWER STRIP:

This eight outlet tap is rated at 15 amps total. Combined

load must not exceed 15 amps or 1875 watts. Use only in dry

indoor locations. Not for use with aquariums. The 15 amp 125

volt AC 8-outlet strip plugs into any 3-wire grounding wall

outlet and provides eight outlets that will accept either 2-blade

non-grounding plugs or 3-blade grounding. The handy, built-in

master switch/circuit breaker allows you to turn power to all

outlets ON or OFF, and will interrupt power in case of an over-

load condition (when outlets are set to be powered).

NOTE: This device is not a surge suppressor and will not afford

protection in the event of power surges.

INSTRUCTIONS:

When the device is plugged in and the master switch is on, the

timer’s dial will turn clockwise. The arrowhead on the face of

the timer points to the current time of day.

1. Locate the segments on the edge of the timer’s dial. Each

of these segments equals 15 minutes. For easy setting, use

a pen or pencil to pull the segments up. To select the hours

you want the ﬁxture turned ON, push down the segments

within these hours on the dial. For example, to have the

timer turn on a ﬁxture between 6 PM and 8 PM and then

again between 10 PM and 2 AM, push down all the seg-

ments between 6 PM and 8 PM, and between 10 PM and

2AM on the timer’s dial.

2. Rotate the timer’s dial clockwise until the arrowhead on the

face points to the current time of day. Note: AM and PM are

marked on the dial with a sun and moon symbol.

3. Set the timer switch at the side of power strip to the TIMER

ON position.

4. Plug the power strip into an electrical outlet convenient to

the ﬁxture to be controlled.

5. Plug the ﬁxture into a timed outlet. Turn the ﬁxture’s switch

ON for automatic control. The timer will not turn the ﬁxture

on if the ﬁxture’s switch and/or power strip switch is OFF.

The ﬁxture will now turn on and off at the times you have

set.

NOTE: To override the timer and use your ﬁxture normally, set

the timer switch to the OUTLET ON position. This will deacti-

vate the timer’s control of the ﬁxture, but the timer’s dial will

still show the current time of day.

To reactivate the timer’s control of the ﬁxture, turn the ﬁxture’s

switch ON and set the timer’s switch to TIMER ON. In case of

power failure, or after turning on the master switch, reset the

time of day as explained in step 2.

15090

Manual Revision 2

11-24-09

www.jascoproducts.com

Made in China

1 2

DEL TEMPORIZADOR 2

Résumé du contenu

Page 1

POWER SAVING STRIP TIMER 8 Outlet Power Strip - 24-Hour Programmable Function with 4 Timed OutletsRATINGS125VAC 15A 60Hz125VAC 1000W Tungsten125VAC 1

Page 2 - DEL TEMPORIZADOR

MULTITOMA CON TEMPORIZADOR AHORRADOR DE ENERGÍAMultitoma de 8 salidas - función programable 24 horas con 4 salidasESPECIFICACIONES125VAC 15A 60Hz125VA

Commentaires sur ces manuels

Pas de commentaire

Ge Plug-In 15090 GE Strip Timer Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Horloge Ge Plug-In 15090 GE Strip Timer. GE Plug-In 15090 GE Strip Timer User Manual [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Horloge Ge Plug-In 15090 GE Strip Timer