GE PGP989 Manuel d'utilisateur télécharger pdf

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com

LP Conversion Gas Cooktop

Instructions

Read these instructions completely and carefully.

•

IMPORTANT

–

Save these

instructions for local inspector’s use.

•

IMPORTANT

–

Observe all

governing codes and ordinances.

• Note to Installer

–

Be sure to leave these

instructions with the Consumer.

• Note to Consumer

–

Keep these

instructions for future reference.

BEFORE YOU BEGIN

• This cooktop is factory set for natural gas operation.

Conversion to LP operation should be performed

by a qualified technician or installer. Keep these

instructions for future reference. When converting

to LP, save the original parts for possible future re-use.

• Product failure due to improper installation is not

covered under the GE Appliance Warranty.

PGP989

WARNING

–

If you are using LP (bottled) gas, all

adjustments described in the following steps must be made

before attempting burner adjustments or use

of the cooktop.

WARNING

–

This conversion kit shall be

installed by a qualified service agency in accordance

with the manufacturer’s instructions and all applicable

codes and requirements of the authority having

jurisdiction. If the information in these instructions

is not followed exactly, a fire, explosion or production of

carbon monoxide may result, causing property damage,

personal injury or loss of life. The qualified service agency

is responsible for the proper installation of this kit. The

installation is not proper and complete until the operation

of the converted appliance is checked as specified in the

manufacturer’s instructions supplied with the kit.

FOR YOUR SAFETY:

Adjustable wrench 9/32″ (7 mm) Nutdriver

TOOLS YOU WILL NEED

T15 Torx driver

PART QUANTITY

Brass orifices 4

Stick-on rating label 1

Installation instructions 1

PARTS INCLUDED WITH COOKTOP

Small, thin-blade flat screwdriver with approximately 1/8″

blade width is needed to access the calibration screw.

49-80554

07-08 JR

Printed in the United States

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Instructions

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comLP Conversion Gas CooktopInstructionsRead these instructions completely an

Page 2 - ELECTRIC SUPPLY

CONVERT SURFACE BURNERSFirst remove, convert and replace the left side surfaceburners and then the right side surface burners.Remove the grates, burne

Page 3

CONVERT SURFACE BURNERS (cont.)Replace the gaskets, burner bases and electrodes.Install the two screws in each burner base. Do notovertighten. The max

Page 4

4ADJUST THE LOW FLAME (SIMMER)SETTINGThe top burner valves have low flame/simmeradjustment screws in the center of the control shafts. A flashlight ma

Page 5 - PARA SU SEGURIDAD:

¿Preguntas? Llame al 800.GE.CARES (800.432.2737) o visite nuestro sitio Web en: ge.comInstrucciones de Estufa de gasconversión a gas LPLea estas instr

Page 6 - Instrucciones de conversión

Instrucciones de conversión• Con la instalación de este kit de conversión, la estufadebe funcionar con gas LP a una presión de columna deagua de 10&qu

Page 7

CONVERSIÓN DE QUEMADORES DESUPERFICIE (cont.)Reemplace las juntas, bases de los quemadores y electrodos. Instale los dos tornillos en cada base de que

Page 8

4AJUSTE LA CONFIGURACIÓN DE LLAMA BAJA (FUEGO LENTO)Las válvulas de los quemadores superiores cuentan con tornillos de ajuste para llama baja/fuego le