GE GDF530PGMCC Manuel d'installation

Naviguer en ligne ou télécharger Manuel d'installation pour Lave-vaisselle GE GDF530PGMCC. GE GDF530PGMCC Installation Instructions Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation Instructions
Built-In Dishwasher
If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our website
at: GEAppliances.com. In Canada, please call 800.561.3344 or visit geappliances.ca
READ CAREFULLY
KEEP THESE INSTRUCTIONS
CHECK THE FOLLOWING
Tub trim does not interfere with the door
Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door
All 4 legs of the dishwasher are firmly in contact with the
floor
Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls
Tub trim is fully seated on the tub flange
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS
shown throughout these instructions.
While performing installations described in this
booklet, gloves, safety glasses or goggles should
be worn.
IMPORTANT – Observe all governing codes and
ordinances.
Note to Installer – Be sure to leave these instructions
for the consumer’s and local inspector’s use.
Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliances Warranty.
See warranty information.
Completion Time – 1 to 3 Hours. New installations
require more time than replacement installations.
IMPORTANT – The dishwasher MUST be installed to
allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed
or removed,
to reduce the likelihood of damage to the
power supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for
available custom panel kits.
Your dishwasher is a water heating appliance.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
31-31586 03-18 GEA
Remove all power leading to the appliance from the
circuit breaker or fuse box before beginning installation.
Failure to do so can result in a risk of electrical shock.
To reduce the risk of electric shock, fire, or injury to persons,
the installer must ensure that the dishwasher is completely
enclosed at the time of installation.
The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative
if you are in doubt that the appliance is properly
grounded. If house wiring is not 2-wire with ground, a
ground must be by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
To reduce the risk of electric shock, fire, or injury to
persons, the installer should check to ensure that wires are
not pinched or damaged, the house wiring is attached to the
junction box bracket through a strain relief, and all electrical
connections made at the time of install (wire nuts) are
contained inside of
the junction box cover.
WARNING
Retire todos los conductores de corriente del
electrodoméstico de disyuntor o de la caja del fusible
antes de comenzar con la instalación. Si no cumple con
esto, se podrá producir el riesgo de descargas eléctricas.
Para reducir el riesgo de descarga eléctrica, incendio
o lesiones a personas, el instalador debe asegurarse
de que el lavaplatos esté completamente cerrado en
el momento de la instalación.
La conexión inadecuada del conductor de conexión a
tierra del equipamiento puede provocar un riesgo de
descarga eléctrica. Consulte a un electricista calificado
o representante de servicio técnico si tiene dudas
sobre la correcta conexión a tierra del aparato. Si el
cableado doméstico no cuenta con un cable de 2 hilos
con conexión a tierra, un instalador debe realizar una
conexión a tierra. Cuando el cableado doméstico es de
aluminio, asegúrese de usar un compuesto antioxidante
y conectores de aluminio a cobre aprobados por UL.
Para reducir el riesgo de descarga eléctrica, incendio
o lesiones a personas, el instalador deberá realizar un
control para asegurar que los cables no estén pellizcados
ni dañados, que el cableado del hogar esté conectado a la
ficha de la caja de empalmes a través de un amortiguador
de refuerzo, y que todas las conexiones eléctricas
realizadas en el momento de la instalación (tuercas para
cables) estén dentro de la tapa de la caja de empalmes.
ADVERTENCIA
Vue de la page 0
1 2 3 4 5 6 ... 31 32

Résumé du contenu

Page 1 - Installation Instructions

Installation InstructionsBuilt-In DishwasherIf you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our website at: GEApplia

Page 2 - Installation Preparation

Dishwasher Installation PUSH DISHWASHER INTO FINAL POSITION (CONT.)• Check dishwasher alignment prior to opening dishwasher door to prevent panel da

Page 3 - DRAIN REQUIREMENTS

Dishwasher Installation11 POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINETIn this step you will need the 2 Phillips special head screws from the

Page 4 - PREPARE ELECTRICAL WIRING

CONNECT DRAIN LINE (CONT.)• Connect drain line to air gap, waste tee or disposer using the previously determined method. Secure hose with a screw-ty

Page 5 - PREPARE HOT WATER LINE

Dishwasher Installation13 CONNECT POWER SUPPLYIf a power cord with plug is already installed proceed to Step 18. In this step you will need the junct

Page 6 - PRECAUCIÓN

Dishwasher Installation14 DISHWASHER WET TEST• Turn on power supply or plug power cord into outlet, if equipped.• Select a cycle to run and push th

Page 7

Dishwasher Installation15 LITERATURE• Be sure to leave complete literature package, these Installation Instructions and product samples and/or co

Page 8

NOTE: Product improvement is a continuing endeavor at GE Appliances. Therefore, materials, appearance and specifications are subject to change without

Page 9

Directives d’installation Lave-vaisselle encastré Pour toute question, composez le 800.561.3344 ou visitez notre site web: electromenagersge.caPOUR

Page 10 - Dishwasher Installation

Préparation pour l’installation2PIÈCES FOURNIES DANS L’EMBALLAGE :• Couvercle de la boîte de jonction et vis à tête hexagonale n° 10• Collier• Bo

Page 11

PRÉPARATION DE L’OUVERTURE DANS LES ARMOIRES• L’ouverture dans les armoires doit mesurer au moins 61,0 cm (24 po) de largeur et de profondeur, et envi

Page 12

PARTS SUPPLIED IN INSTALLATION PACKAGE:• Junction box cover and #10 hex-head screw• Hose clamp• Drain hose (approximately 58” long)• Drain hose h

Page 13 - ADVERTENCIA

PRÉPARATION DU CÂBLAGE ÉLECTRIQUEAlimentation électrique• Cet appareil doit être alimenté par un courant de 120 V et +]HWEUDQFKpjXQFLUFXLW

Page 14

5Préparation pour l’installationPRÉPARATION DE L’ALIMENTATION EN EAU CHAUDEREMARQUE: GE Appliances recommande l’utilisation d’un tuyau en cuivre pour

Page 15

Installation du lave-vaisselle6 ENLÈVEMENT DU PANNEAU INFÉRIEURPassez cette étape si la plinthe n’est pas préinstallée sur l’appareil. Sur certains m

Page 16

POSITIONNEMENT DE LA CONDUITE D’EAU ET DE L’ALIMENTATION ÉLECTRIQUE• Positionnez la conduite d’alimentation en eau et le câblage de la résidence sur

Page 17 - Directives d’installation

INSTALLATION DES MOULURES (certains modèles)Sautez cette étape si aucune moulure n’est fournie avec le lave-vaisselle. Au cours de cette étape, vou

Page 18 - MATÉRIAUX NÉCESSAIRES :

9Installation du lave-vaisselle INSTALLATION DES SUPPORTS DE MONTAGEVous aurez besoin des supports de montage et de deux (2) vis à tête hexagonale no

Page 19 - PRÉPARATION DE L’OUVERTURE

MISE DE NIVEAU DU LAVE-VAISSELLE (SUITE)• Enlevez le panier inférieur et placez un niveau sur la porte et sur le rail du panier inférieur, comme ind

Page 20 - ÉLECTRIQUE

11Installation du lave-vaisselle FIXATION DU LAVE-VAISSELLE AU-DESSOUS DU COMPTOIR OU AUX CÔTÉS DES ARMOIRESAu cours de cette étape, vous aurez besoi

Page 21 - EAU CHAUDE

RACCORDEMENT DU BOYAU DE VIDANGE (SUITE)• Branchez le boyau de vidange à la coupure anti-refoulement, au raccord en T ou au broyeur à déchets jO¶DL

Page 22 - 1/2"

Installation du lave-vaisselle13 BRANCHEMENT DE L’ALIMENTATION ÉLECTRIQUESi un cordon d’alimentation pourvu d’une fiche est déjà installé sur l’appar

Page 23

PREPARE DISHWASHER ENCLOSURE• The rough cabinet opening must be at least 24” deep, 24” wide and approximately 34-1/2” high from floor to underside of

Page 24 - Do not push against

Installation du lave-vaisselle ESSAI DU LAVE-VAISSELLE AVEC DE L’EAU• Rétablissez l’alimentation électrique ou si l’appareil est doté d’un cordon d

Page 25

Installation du lave-vaisselle15 INSTALLATION DU PANNEAU INFÉRIEUR• Appuyez le panneau inférieur contre les pieds de nivellement du lave-vaisselle.•

Page 26 - Turn Legs

NOTE: Chez GE Appliances, nous nous efforçons continuellement d’améliorer les produits. Par conséquent, les matériaux, l’aspect et les caractéristique

Page 27 - Wood Countertop

Installation PreparationFor models equipped with power cord: Do not modify the plug provided with the appliance; if it will not fit the outlet, have a

Page 28 - Drain Hose Hanger

Water Line Connection• If using a flexible braided supply hose, label the hose with the installation date to use as reference. Flexible braided hoses,

Page 29 - AVERTISSEMENT

ToekickRemove 2Toekick Screws REMOVE TOEKICK Skip this step if the toekick is not pre-installed on the unit. On some models the toekick is packaged s

Page 30

STEP 7 POSITION WATER LINE AND HOUSE WIRING• Position water supply line and house wiring on the floor of the opening to avoid interference with base

Page 31 - Panneau inférieur

INSTALL TRIM PIECES (on some models)Skip this step if trim is not supplied with the dishwasher.In this step you will need the trim pieces set aside

Page 32

Dishwasher Installation9 INSTALL MOUNTING BRACKETSYou will need the mounting brackets and 2 #8 hex-head screws set aside in Step 1.You must install t

Commentaires sur ces manuels

Pas de commentaire