GE GPF825W Manuel d'installation

Naviguer en ligne ou télécharger Manuel d'installation pour Lave-vaisselle GE GPF825W. GE GPF825W Installation Instructions [ja] [zh] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Before you begin – Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference.
CAUTION
To prevent electric shock, disconnect
electrical power supply to dishwasher
before changing panels. Do not operate
dishwasher while changing panel.
STEP 1 CUT 1/4" THICK CUSTOM PANEL TO SIZE
Tools and Materials Required:
• Stubby Phillips screwdriver
• Gloves to protect against sharp edges
• Safety glasses
The GPF825 trim kits provide for the installation
of a 1/4" thick custom door panel.
This kit includes:
Installation Instructions
GPF825
Series Kits
GPF825B, Black Trim Kit
GPF825C, Bisque Trim Kit
GPF825W, White Trim Kit
• Cut door panel to the dimensions shown in Figure 1.
NOTE: The trim provided will conceal the cut edges of
the panel.
1/4" Thick
Door Panel
23-1/2"
25-1/16"
WARNING
Fully Assembled Door Panel Frame
2 Door Springs
To Be Used On All Models
Except PDW8500
On new installations, do not remove wood base until you
are ready to install the dishwasher. The dishwasher will
tip over when the door is opened.
Figure 1
Adjustable
Steel Panel
Top
Trim
Side Trim
Bottom
Trim
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Installation Instructions

Before you begin – Read these instructions completely and carefully.IMPORTANT: Save these instructions for local inspector’s use.IMPORTANT: OBSERVE A

Page 2 - STEP 2 REMOVE DOOR PANEL

Top Trim Screws2STEP 2 REMOVE DOOR PANEL• Open dishwasher door.• Remove the 6 Phillips head screws along the sides ofthe door (Figure 2) holding the

Page 3 - STEP 5 REPLACE DOOR SPRINGS

STEP 4 INSTALL THE ASSEMBLED PANEL• Close the dishwasher door.• Slide the panel assembly into the escutcheon tab(Figure 7).• Reinstall the two screws

Page 4 - STEP 5A TEST DOOR BALANCE

Pub. No. 31-30552 SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. DWG. NO. 206C1559P091(N.D. 551) 7/02STEP 5A TEST DOOR BALANCE• Release door latch.

Commentaires sur ces manuels

Pas de commentaire