Ge 500A436P006 Manuel d'utilisateur télécharger pdf

Installation

Gas Dryer

Instructions

if you have any questions, call 1-800-GECARES (US) or 1-800-361-3400 (Canada)

or Visit our Web site at: WWW. GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and

carefully.

«IMPORTANT “ Save these

instructions for local inspector’s use.

«IMPORTANT “ Observ'e

all governingcodes and ordinances.

® Note to Installer - Be sure to leave

these instructions with the customer.

® Note to Customer - Keep these

instructions with your Use and Care

Book for future reference.

® Before the old diyer is removed from

sendee or discarded, remove the diy'er

door.

» Inspect the diyer exhaust outlet and

straighten the outlet walls if they are

bent.

® Sendee information and the wdring dia

gram are located in the control console.

® Do not allow children on or in the

appliance. Close supendsion of child

ren is necessaiy when the appliance is

used near children.

® Install the diyer where the temp

erature is above 50°F for satisfactory

operation of the diyer control system.

TOOLS YOU

WILL NEED

^ (OlI

-----

s J

10" ADJUSTABLE WRENCHES

8" PIPE WRENCH

SLIP JOINT PLIERS FLAT BLADE SCREWDRIVER

LEVEL

AWARNING

RISK OF FIRE

To reduce the risk of severe injuiy or death, follow all installation instructions.

Clothes diyer installation must be performed by a qualified installer.

Install the clothes diyer according to these instructions and in accordance with

local codes. In the absence of local codes, installation must comply with National

Fuel Gas Code, ANSIZ223.I/NFPA 54 or the Canadian Natural Gas and Propane

Installation Code, CSA B 149.1.

California Safe Drinking Water and Toxic Enforcement Act

This act requires the governor of California to publish a list of substances known to the

state to cause cancer, birth defects or other reproductive harm and requires businesses to

warn customers of potential exposure to such substances. Gas appliances can cause minor

exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde

and soot, caused primarily by the incomplete combustion of natural gas or LP fuels.

Properly adjusted divers will minimize incomplete combustion. Exposure to these

substances can be minimized further by properly venting the diyer to the outdoors.

This diyer must be exhausted to the outdoors.

Use only 4” rigid metal ducting for exhausting the clothes diyer to the outdoors.

DO NOT install a clothes diyer with flexible plastic ducting materials. If flexible

metal (semi-rigid or foil-type) duct is installed, it must be UT-listed and installed

in accordance with the instructions found in "Connecting The Diyer To House

Vent" on page 6 of this manual. Flexible ducting materials are known to collapse,

be easily crushed, and trap lint. These conditions will obstruct diyer aiiflow and

increase the risk of fire.

Do not install or store this appliance in any location where it could be exposed to

water and or weather.

Save these instructions. (Installers: Be sure to leave these instructions with the

customer).

In the state of Massachusetts, installation must be performed by a qualified

or licensed contractor, plumber, or gasfitter qualified or licensed by the state.

4" DIA. METAL DUCT

(RECOMMENDED)

) MATERIALS YOU WILL NEED

PIPE

4” DIA. FLEXJBLEJEm^SEMLRiGID)

4' DIAM METAL ELBOW EXHAUST HOOD COMPOUND SOAP SOLUTION

FOR LEAK DETECTION

UL LISTED TRANSITION DUCT

(IF NEEDED)

KIT WX08X10077 (INCLUDES 2 ELBOWS)

4” DIA. FLEXIBLE METAL (FOIL TYPE)

UL LISTED TRANSITION DUCT

(IF NEEDED.)

4” DUCT CLAMPS

4” SPRING CLAMPS

FLEXIBLE GAS LINE CONNECTOR Gl-OVES

Step 1

Step 2

Step .I

Step 4

Step 5

Step 6

Step 7

Verify Your Gas Installation (see section 2).

Prepare the Area and Exhaust for Installation of

New Diyer (see section 1).

Check and Insure the Existing External Exhaust is

Clean (see section 1) and Meets Attached Installation

Specifications (see section 6).

Remove the Foam Shipping Pads (see section 1).

Move the Diyer to the Desired Eocation.

Eevel Your Diyer (see section 8).

Connect the Gas Supply (see section ,8) and check

for leaks (see section 4).

Step 8 Connect the External Exhaust (see section 7).

Step 9 Connect the Power Supply (see section 5).

Step 10 Check the Operation of the Power Supply, Gas

Connections, and Venting.

Step 11 Place the Owners Manual and the Installation

Instructions in a Eocation Where They Will Be

Noticed By the Owner.

For Alcove or Closet Installation see section 9.

For Bathroom or Bedroom Installation see section 10.

For Mobile or Manufactured Home see section 11.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Instructions

InstallationGas DryerInstructions06if you have any questions, call 1-800-GECARES (US) or 1-800-361-3400 (Canada) or Visit our Web site at: WWW. GEAppl

Page 2 - A WARNING

IViinimum Clearance Other Than Alcove or Closet installationMinimum clearance to combustible surfaces and for air opening are: 0 in. clearance both si

Page 3 - FLAME TO TEST FOR GAS LEAKS

installation instructions3J RECOIMiMECTiiMG GASListed connector ANSI Z21.24 / CSA 6.10Note: The connector and fittings are designed for use only on th

Page 4 - EXHAUST INFORMATION

installation instructions1 ELECTRICAL CONNECTIONINFORMATIONA WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL S HOCK, AND PERSONAL INJURY:• DO NOT USE

Page 5 - 8 LEVELING DRYER

instailatiori instructionsm EXHAUST CONNECTIONAWARNING - TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY:® This clothes diyer must be exhausted to the o

Page 6 - HOME INSTALLATION

instailatiori instructionsCOIMiMECTIIMG THE DRYER TO HOUSE VENTRIGID METAL TRANSITION DUCT® For best diying performance, a rigid metal transition duct

Page 7 - Installation Instructions

Installation Instructionsm DRYER EXHAUST TO LEFT OR BOTTOM CABINET^ WARNING - BEFORE PERFORMING THIS EXHAUST INSTALLATION, BE SURE TO DISCONNECT THE D

Page 8 - A WARNING - LABEL ALL WIRES

installation instructionsADDING ELBOW FOR EXHAUST THROUGH BOTTOM OF CABINET* Insert the elbow through the rear opening and connect it to the dtyer int

Commentaires sur ces manuels

Pas de commentaire

Ge 500A436P006 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Séchoirs Ge 500A436P006. GE 500A436P006 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Ge 500A436P006