GE Lighting Luminaire Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Lumières des projecteurs GE Lighting Luminaire. GE Lighting Luminaire Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 7
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
GEH-5930
INSTRUCTIONS
Criterion
TM
Large Horizontal
Area Fixture 750-1000 Watt
READ THOROUGHLY BEFORE INSTALLING
GENERAL
This luminaire is designed for outdoor lighting
applications, and should not be used in areas of limited
ventilation, or in high ambient temperature enclosures.
For optimum performance, it should be installed and
maintained according to the following recommendations.
UNPACKING
This luminaire has been properly packed so that no parts
should have been damaged during transit. Inspect to
confirm.
INSTALLATION
This luminaire has been configured specifically to
mount to a round or square pole. To facilitate mounting,
open the door by releasing the two latches and swinging the
door open. The reflector may be removed by rotating the
two fasteners 90 degrees and remove the reflector from the
luminaire. Disconnect the socket leads to free reflector
from the luminaire. SnapDrive™ may be removed for ease
of installation. To remove, invert luminaire, unscrew and
discard shipping screw (if so equipped), disconnect the
wire harness, then depress the spring clips downward,
rotate SnapDrive upward and lift off of the hinges
(see Figure 1).
A. MOUNTING
WARNING
Risk of electric shock
Turn power off before servicing
see instructions
WARNING
Risk of fire
Use supply wire specified on
nameplate
CAUTION
Unit will fall if not installed properly
Follow installation instructions
For mounting to pre-drilled poles see Figure 2 for round
poles and Figure 3 for square poles. To mount luminaire to
pole:
1. Install nut plate inside the pole. Nut plate can be secured
inside pole with screw provided.
2. Install two (2) studs, ensuring full penetration into nut
plate.
SnapDrive Hinge
SnapDrive
Spring Clip
Figure 1
g
GE
Lighting Solutions
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred
to GE Lighting Solutions.
Vue de la page 0
1 2 3 4 5 6 7

Résumé du contenu

Page 1 - Area Fixture 750-1000 Watt

GEH-5930INSTRUCTIONSCriterionTM Large HorizontalArea Fixture 750-1000 WattREAD THOROUGHLY BEFORE INSTALLINGGENERALThis luminaire is designed for outdo

Page 2 - B. WIRING

3. Align inside of mounting arm with studs and slide it intoplace against pole.4. Install luminaire and secure with flat washers andlocknuts provided.

Page 3 - MAINTENANCE AND CLEANING

LAMP INSTALLATIONCAUTIONRisk of burn• Allow lamp/fixture to cool beforehandlingWARNINGRisk of burn• Do not touch operating luminaireUse only lamps spe

Page 4 - ATTENTION

GEH-5930INSTRUCTIONSLuminaire horizontalCriterionTM à éclairage large 750-1000 wattsLIRE ATTENTIVEMENT AVANT D'INSTALLERGÉNÉRALITÉSCe luminaire a

Page 5 - B. CÂBLAGE

3. Alignez l'intérieur du bras de montage avec les goujonset faites-le glisser en place contre le poteau.4. Installez le luminaire, puis fixez-le

Page 6

INSTALLATION DE LA LAMPEUtilisez uniquement des lampes conformes auxexigences de la plaque signalétique. Respectez lesrecommandations du fabricant de

Page 7 - 16943533----888

35-201578-123 (4/03)gGE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solution

Commentaires sur ces manuels

Pas de commentaire