GE SmartHome™Wireless Lighting ControlOn/Off/DimLamp Module45602Z-Wave® Certified Wireless Lighting Control
All On/All OffDepending upon your primary controller, the 45602 lamp module can be set to respond to ALL ON and ALL OFF commands in up to four differe
Dim Rate AdjustmentsBoth the number of steps (or levels) that the dimmer will change and the timing of the steps can be modified to suit personal prefe
Ignore Start Level When Receiving Dim CommandsPlease note: Every “Dim” command from your remote controller includes a start level embedded in it. The
Interoperability with Z-Wave™ DevicesA Z-Wave™ network can integrate devices of various classes, and these devices can be made by different manufactur
FCC U2Z45602-3The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:The equipment has been test
Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the ant
is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma
Introduction:Thank you for your purchase of a GE Z-Wave® control device. Z-Wave® technology is designed to automate lighting/home control and provide
Manual/Program buttonStandard AC outlet Z-wave outlet (other end)to the system and will also act as range extenders if they support this functio
There are no user serviceable parts in this unit. To reduce the risk of electric shock, this product has a grounding type plug that has a third (grou
Wireless RangeThis device complies with the Z-Wave standard of open-air, line of sight transmission distances of 65 feet. Actual performance in a hom
Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu
Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.
Basic OperationThe connected light can be turned ON in three ways:With a Z-wave remote.Manually with the pushbutton on the Z-Wave module.By the Load-
2. Adjust the brightness level of the connected lighting by pressing and holding the button. Release the button when the desired level is atta
Commentaires sur ces manuels