If you have questions, call 800.626.2000 or visit our website at: www.monogram.comInstallationInstructions36” Chimney Vent HoodZV800monogram.com49-802

10Installation Instructions3 INSTALL DUCT BRACKETThe duct bracket must be intalled against the ceiling. This bracket will hold the duct cover in plac

11Installation Instructions4 PREPARE THE HOOD Remove the hood from the box. Remove packaging and tape. Remove one screw on each side of the cover

7 CONNECT ELECTRICALVerify that power is turned off at the source.WARNING: If house wiring is not 2-wire with a ground wire, a ground must be provide

8 INSTALL DUCT COVERS Place the decorative duct covers on top of the hood. NOTE: The inside (upper) duct piece has holes on one end. The holes ar

14Installation InstructionsDUCTWORK, WIRING LOCATIONS Determine the exact location of the vent hood. Locate the template packed with the literatur

15Installation Instructions2 INSTALL MOUNTING BRACKETThis vent hood must be secured to the horizontal support or wall studs. With the template tape

16Installation Instructions:$//02817(',167$//$7,21³5(&,5&8/$7,1*4 MOUNT THE HOOD Lift the hood onto the mounting bracket. Check to

17Installation Instructions:$//02817(',167$//$7,21³5(&,5&8/$7,1*6 CONNECT ELECTRICALVerify that power is turned off at the source.WARNI

18Installation Instructions8 INSTALL FILTERSCharcoal filter Remove protective film on the filters. Install the black charcoal filter into the cent

19Installation InstructionsCABINET REQUIREMENTSThis hood may be installed beneath a wall-mounted cabinet. If the cabinet has been installed, it must

Safety Information2BEFORE YOU BEGIN Read these instructions completely and carefully.IMPORTANT³ Save these instructions for local inspector’s use.

20Installation InstructionsUNDER-CABINET INSTALLATION1 INSTALL FRAMING FOR HOOD SUPPORT IMPORTANT: Framing must be capable of supporting 100 lbs.If d

21Installation Instructions4 INSTALL SIDE “L” BRACKETS Install the “L” brackets onto each side of the cutout. The wide flat portion should be on to

22Installation InstructionsUNDER-CABINET INSTALLATION7 COMPLETE THE INSTALLATION AND CONNECT DUCTWORK Drive 2 screws into each side bracket. Be

23Installation Instructions8 CONNECT ELECTRICALWARNING: If house wiring is not 2-wire with a ground wire, a ground must be provided by the installer

49-80267-301-13 GEPrinted in ItalyNOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram

INSTALLATION OPTIONSWALL-MOUNTED INSTALLATIONSThis hood may be installed onto a wall and vented to the outdoors, or it can be installed for recirculat

Installation Preparation4ADVANCE PLANNING Determine the exact location of the vent hood. Plan the route for venting exhaust to the outdoors. Use t

DUCT FITTINGSUse this chart to compute maximum permissable lengths for duct runs to outdoors.NOTE: Do not exceed maximum permissable equivalent length

6Installation PreparationREMOVE THE PACKAGING Remove the duct cover, parts box and other packaging. Lift the hood out of the box. Remove and pro

INSTALLATION BELOW A WALL CABINETOrder a cabinet that is at least 20” high from the bottom frame to the inside top. The cabinet must be at least 12”

8CHECK INSTALLATION HARDWARELocate the hardware accessory box packed with the hood and check contents.Installation Preparation29-7/8"11-1/2"

91 INSTALL FRAMING FOR HOOD SUPPORT IMPORTANT³Framing must be capable of supporting 100 lbs.If drywall is present, mark the screw hole locations fo