InstallationInstructions36" Glass Canopy Chimney Vent HoodZV90049-80328-3
Installation Instructions3 INSTALL DUCT BRACKETThe duct bracket should be installed against the back wall and flush with the ceiling. This bracket wi
11Installation Instructions PREPARE THE HOOD• Place the hood on a padded surface.• Position the motor housing at the back of the hood. Electrical
7CONNECT DUCTWORK• Install ductwork, making connections in the direction of airflow as illustrated.• Push duct over the exhaust outlet and damper.•
13Installation Instructions,167$//$7,21³9(17('727+(2876,'( CONNECT ELECTRICALVerify that power is turned off at the source.WARNING: If
INSTALL DUCT COVERS• Place the decorative duct covers on top of the hood. NOTE: The inside (upper) duct piece has holes on one end. The holes are
15Installation Instructions,167$//$7,21³5(&,5&8/$7,1*DUCTWORK, WIRING LOCATIONS• Determine the exact location of the vent hood.• Locate the
Installation Instructions,167$//$7,21³5(&,5&8/$7,1*163 INSTALL DUCT BRACKETThe duct bracket should be installed against the back wall and flu
17Installation Instructions,167$//$7,21³5(&,5&8/$7,1* PREPARE THE HOOD• Place the hood on a padded surface.• Position the motor housing at
CONNECT ELECTRICALVerify that power is turned off at the source.WARNING: If house wiring is not 2-wire with a ground wire, a ground must be provid
19Installation Instructions,167$//$7,21³5(&,5&8/$7,1* INSTALL FILTERSIMPORTANT: Check to be sure that the main ON/OFF switch next to the mot
Safety Information2BEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT³ Save these instructions for local inspector’s use.
NOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram® local service in your area, call
INSTALLATION OPTIONSNOTE: Installation height should be measured from the cooking surface to the outer glass sides.This hood may be installed onto a w
Installation Preparation4ADVANCE PLANNING• Determine the exact location of the vent hood.• Plan the route for venting exhaust to the outdoors.• Use t
DUCT FITTINGSThis Hood Must Use an d Round Duct. It Can Transition to a d[d Duct.Use this chart to compute maximum permissible lengths for
Installation PreparationREMOVE THE PACKAGINGCAUTION: LIFT THE HOOD OUT OF THE BOX BY THE CENTER METAL PORTION. DO NOT LIFT BY THE GLASS SIDES.PRUDENCE
7:DOO0RXQW=9 Installation Heights Actual *Possible Ceiling *Possible VENTED RECIRCULATING Height Installation Height Installation Heig
CHECK INSTALLATION HARDWARELocate the hardware accessory box packed with the hood and check contents.Installation Preparation29-7/8"11-1/2"1
9 INSTALL FRAMING FOR HOOD SUPPORT IMPORTANT³ Framing must be capable of supporting 100 lbs.If drywall is present, mark the screw hole locations fo
Commentaires sur ces manuels