GE BL Series Guide d'installation télécharger pdf (Page 6)

IND076-082313

01333785

GE Lighting • gelighting.com

GE Lighting is a subsidiary of the General Electric Company. Lumination is a trademark of GE Lighting Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.

Troubleshooting

Symptom Solution

Luminaire does not light • Check input voltage and check power supply input/output connections.

• Check circuit breaker.

Luminaire is dim • Dimming wire connection shall be checked and if connection is not proper, reconnect it.

If wire is harmed, replace it with an intact one. Also check that dimming wires are not in

short circuit.

Luminaire is blinking • Ensure power supply temperature does not exceed its maximum rating.

• Refer to the tc point located on power supply.

Luminaire does not dim • Check dimming wire connection.

Luminaires will not turn on • Check that the color of the supply side wires match the color of the wires they are

connected to.

• Check that the LED driver connector is fully engaged to the LED light engine connector.

• Check that the LED light engines are connected at the junction between the two

luminaires.

Luminaire on through

wiring will not turn on

• Check that the through wiring connector from the previous xture in the linear row is fully

engaged to the malfunctioning luminaire.

2 3

Place diffuser to be trimmed on a clean surface.

Apply masking tape over cutting area. Score plastic

with utility knife to about 50% of plastic thickness.

Position score over table edge and carefully snap

off end. Remove tape, le edge, and clean. Install

diffuser as instructed in Step 1.

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

GE BL Series Guide d'installation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour motos GE BL Series