GE BL Series Guide d'installation télécharger pdf (Page 4)

For the luminaires that will be in the middle of the run,

insert two pins into one end only. Slide pins into the

bottom screw grooves, leaving approximately 20-22mm

exposed.

Pre-install the two M3x12 mm screws with the wingnuts

into bracket. The screws should be in the same hole type.

3 4

Insert four mounting brackets (two per side) into

grooves on both sides of luminiare. Position brackets

approximately 2-3mm from ends. Do not tighten

wingnuts yet.

Fasten one end cover (BL4X - SKU 85598, BL6X - SKU 63263)

on the rst and last luminaires only with four M3 screws.

Always use a star washer under one of the top screws to

ensure ground continuity. Use retained end covers, star

washers and screws.

Note: The luminaires between the rst and last luminaire

do not require end covers.

Place luminaires into ceiling grid.

Do not

tighten yet

Must use star

washer on top hole

20-22mm

End cover

First luminaire Middle luminaire(s) Last luminaire

End coverNo end covers

Pins

Ceiling grid

Pins

Joiner Pin

Luminaire Installation

Safety screw holes.

One is needed,

more are optional.

With the supplied universal bracket the product is

compatible with the following USG type grids:

DX, DXI, DXT, DXF, DXM.

Reference diagram (right) to determine which hole to

use for a given grid.

1 2 3 4 5 6

Pas de commentaire

GE BL Series Guide d'installation Page 4