Ge PVB94STSS Manuel d'utilisateur télécharger pdf (Page 11)

1 INSTALL DOWNDRAFT VENT

Two stabilizing brackets must be installed on

each side of the downdraft vent.

• For right-side or straight-down blower

discharge, fasten the stabilizing brackets at

locations A, B, D and E.

• For left-side blower discharge, fasten the

stabilizing brackets at locations B, C, D and E.

Place the downdraft vent into the countertop

FXWRXWVRWKDWWKHEDFNÀDQJHRIWKHYHQWLV

sitting on top of the countertop.

Note: The downdraft vent may need to be

WXUQHGDWDQDQJOHWR¿WLQWRWKHFRXQWHUWRS

cutout.

Secure the screws for the stabilizing brackets to

the cabinet back and side walls.

Check that the downdraft vent is vertically level.

Operate the vent 3 to 5 times to ensure proper

installation.

Installation Instructions

2 INSTALL DUCTWORK

• The downdraft blower system is designed for use

ZLWK[GXFWZRUN,WFDQEHWUDQVLWLRQHGWR

6" round.

'XFWZRUN0867EHYHQWHGWRWKHRXWVLGH³QHYHU

in a crawl space, attic or other enclosed space.

• 6" PVC duct should be used when installing under a

concrete slab.

NOTE: Local building code must be followed for

installation in specifying approved type and schedule

of PVC duct used.

'212786(ÀH[LEOHSODVWLFGXFWLQJ

• Always use appropriate roof or wall cap with damper.

/DXQGU\W\SHZDOOFDSVVKRXOGQHYHU

be used.

• Use the straightest duct run possible.

• For satisfactory performance, the duct run should

not exceed 100 ft. or its equivalent length when

EHQGVRUYDULRXV¿WWLQJVDUHXVHG5HIHUWRWKHWDEOH

of equivalent lengths to calculate your installation.

• Install ductwork so the piece of duct nearest the

downdraft unit slots INTO the next piece of the duct.

6HFXUHWKHMRLQWVZLWKVHOIWDSSLQJVFUHZVDQGDSSO\

duct tape around the joints to ensure an airtight seal.

Duct Tape

Over Seam and Screw

Screw

Air

Flow

Bracket

Cabinet Back

Wall

Downdraft Vent

Location A

TOP VIEW

Place Cooktop into the countertop cutout. There

should be a 1/8” minimum gap between the

front of the vent trim and the rear of the cooktop.

It may be necessary to readjust the cooktop and

repeat steps C and D.

4 to 5”

Top

Brackets

Bottom

Brackets

Level

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ge PVB94STSS Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Dispositifs optiques Ge PVB94STSS