GE JB988SK Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fours GE JB988SK. GE JB988SK User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT — Save these
instructions for local inspector’s use.
IMPORTANT — Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with consumer.
Note to consumer – Keep these
instructions for future reference.
Skill level – Installation of this appliance
requires a qualified installer or electrician.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is
not covered under warranty.
FOR YOUR SAFETY:
If you did not receive an anti-tip bracket with your purchase,
call 1-800-626-8774 to receive one at no cost. (In Canada,
call 1-800-561-3344.) For installation instructions of the bracket,
visit: www.geappliances.com. (In Canada, www.geappliances.ca.)
Installation Instructions
Free-Standing Electric Ranges
MATERIALS YOU MAY NEED TOOLS YOU WILL NEED
Anti-Tip Bracket
Kit Included
(UL Listed 40 AMP)
4-Wire Cord 4‘ long OR
3-Wire Cord 4‘ long
Squeeze Connector
(For Conduit
Installations Only)
REMOVE PACKAGING MATERIALS: Failure to remove packaging
materials could result in damage to the appliance. Remove all packing parts from oven,
racks, heating elements and drawer. Also, remove protective film and labels on the outer
door, cooktop and control panel.
1
Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level
Tin Snips
Tape Measure
Pliers
1/4” Nut Driver
Questions? Call 1-800-GE-CARES (1-800-432-2737) or visit www.geappliances.com
In Canada, call 1-800-
561-3344
or visit www.geappliances.ca
WARNING
Before
beginning the installation, switch
power off at service panel and
lock the service disconnecting
means to prevent power from
being switched on accidentally.
When the service disconnecting
means cannot be locked,
securely fasten a prominent
warning device, such as a tag,
to the service panel.
PREPARE THE OPENING (FOR INDOOR USE ONLY)
See illustrations for all rough-in and spacing dimensions. The range may be placed with 0”
clearance (flush) at the back wall and side walls of the cabinet.
2
2
1
2
2
1
2
7
1
2
25”
47
25
3
8
7”
14
1
2
On models with baking
or warming drawers,
electrical outlet must
not be in this area.
3
1
4
3
1
4
7
3
4
23
1
2
47”
29
7
8
25
3
8
45”
36”
SINGLE OVEN
DOUBLE OVEN
A
NOTE C
B
A
C
Both
Sides
NOTE: Use a 4 power cord to prevent interference
with the storage drawer. Power cords 4
1
2
to 6 long
may have to be dressed to allow for proper drawer
closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A. Make sure the wall covering, countertop, flooring
and cabinets around the range can withstand
the heat (up to 200°F) generated by the range.
B. Allow 30” minimum clearance between surface
units and bottom of unprotected wood or metal
cabinet, or allow a 24” minimum when bottom of
wood or metal cabinet is protected by no less
than 1/4” thick flame retardant millboard covered
with not less than No 28 MSG sheet metal,
(.015”), .015” thick stainless steel, .024”
aluminum or .020” copper.
Acceptable electrical outlet area.
Orient electrical receptacle so the
length is parallel to floor.
* GE-branded models have control
panels 30-
7⁄8” wide.
30”
47
5
8
30”
C. This appliance has been approved for 0” spacing to adjacent surfaces above the cooktop.
However, a 6” minimum spacing to surfaces less than 15” above the cooktop and adjacent
cabinet is recommended to reduce exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage
space above the cooktop should be avoided. If cabinet storage space is to be provided above the
cooktop, the risk can be reduced by installing a range hood that projects at least 5” beyond the
front of the cabinets. Cabinets installed above the cooktop must be no deeper than 13”.
29
7
8
*
*
4”
4”
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Free-Standing Electric Ranges

BEFORE YOU BEGINRead these instructions completely and carefully.•IMPORTANT — Save theseinstructions for local inspector’s use.•IMPORTANT — Observe al

Page 2 - Wire cover

ELECTRICAL REQUIREMENTSWARNING: This appliance must be properly grounded.WARNING: All new constructions, mobile homes, recreational vehicles and insta

Page 3 - 4-WIRE INSTALLATION

Wire tipsTerminal blockConduit3-WIRE INSTALLATIONWARNING:The neutral or ground wire of the power cord must be connected to the neutral terminal locate

Page 4

REPLACE THE WIRE COVERReplace wire cover on range back by sliding its left edge under the retaining tabs and replacethe screws removed earlier. Make s

Page 5 - Instrucciones de instalación

ANTES DE COMENZARLea estas instrucciones por completo y condetenimiento. •IMPORTANTE — Guarde estasinstrucciones para el uso de inspectoreslocales.•IM

Page 6 - ADVERTENCIA:

REQUERIMIENTOS ELÉCTRICOSADVERTENCIA:Esta unidad debe contar con una adecuada conexión a tierra. ADVERTENCIA: Todas las construcciones nuevas, casas r

Page 7 - INSTALACIÓN DE 4 ALAMBRES

INSTALACIÓN DE TRES (3) ALAMBRESADVERTENCIA:El cable neutral o a tierra del cable de energía debe estar conectado a la terminal neutral ubicada en el

Page 8 - DE PROTECCIÓN

REEMPLACE LA TAPA DE LOS CABLESReemplace la tapa de los cables de la cocina deslizando el lado izquierdo bajo las lengüetasde retención y reemplazando

Commentaires sur ces manuels

Pas de commentaire