GE GXWH35F Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Articles sanitaires GE GXWH35F. GE GXWH35F Instructions / Assembly Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
REQUIRED TOOLS AND ACCESSORIES
FOR INSTALLATION
2 Adjustable wrenches
Pipe cutter
Ruler or tape measure
Cordless drill
File
Emery paper
Screwdriver
Additional installation parts may be required:
2 fittings to connect household plumbing to 1female NPTF
threads on filter housing.
UL-approved grounding clamps and 6-gauge copper
grounding wire.
Teflon tape
Optional accessories are available (Visa, MasterCard or Discover cards
accepted) by visiting our Website at GEAppliances.com or from Parts and
Accessories, call 800.626.2002 (U.S.) or 800.663.6060 (Canada).
CONTENTS INCLUDED WITH PRODUCT
Filter housing and head
Product literature
Canister wrench
Timer and batteries
Mounting bracket
4 Hex-head screws and 4 Hex washer-head screws
1
GE SmartWater
INSTALLATION INSTRUCTIONS
Heavy-Duty Water Filtration System—GXWH35F (filters not included)
SAFETY PRECAUTIONS
Check with your state and local public works department for
plumbing and sanitation codes. You must follow these guidelines
as you install the Heavy-Duty Water Filtration System. Using a
qualified installer is recommended.
Be sure the water supply conforms with the Performance Data.
If the water supply conditions are unknown, contact your
municipal water company.
WARNING:Do not use with water that is
microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
It is highly recommended that a water shut-off valve be placed
directly upstream of your household filter.
Check with your local public works department for plumbing codes.
You must follow their guides as you install the Heavy-Duty Water
Filtration System.
Use the Heavy-Duty Water Filtration System on a potable, safe-to-
drink, home COLD water supply only. The filter cartridge will not
purify water or make unsafe water safe to drink. DO NOT use on HOT
water (100°F max).
Protect the Heavy-Duty Water Filtration System and piping from
freezing. Water freezing in the system will damage it.
Your Heavy-Duty Water Filtration System will withstand up to 100 psi
water pressure. If your house water supply pressure is higher than
100 psi during the day (it may reach higher levels at night), install
a pressure-reducing valve before the system is installed.
Do not install on HOT WATER. The temperature of the water
supply to the Heavy-Duty Water Filtration System must be
between the minimum of 40°F. and the maximum of 100°F.
See the Performance Data section.
Do not install the Heavy-Duty Water Filtration System using
copper solder fittings. The heat from the soldering process
will damage the unit.
WARNING:Discard all unused parts and packaging
material after installation. Small parts remaining after installation
could be a choke hazard.
Do not install filter in an outside location or anywhere it will be
exposed to sunlight.
PROPER INSTALLATION
This Heavy-Duty Water Filtration System must be properly installed and located in accordance with the Installation Instructions
before it is used.
GXWH35F is
Tested and Certified by NSF International
against NSF/ANSI
Standard 42 with cartridge FXHTC
for the reduction of Chlorine, Taste and Odor.
184D1061P002 (06--09 JR) 49-50201-5
GEAppliances.com
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - GE SmartWater

REQUIRED TOOLS AND ACCESSORIES FOR INSTALLATION 2 Adjustable wrenches Pipe cutter Ruler or tape measure Cordless drill File Emery paper Screwdr

Page 2 - Typical installation

Reemplazo del cartucho del filtroUsted debería cambiar el filtro cuando el paso del agua disminuye notablemente o por lo menos cada tres meses.Cierre

Page 3

INSTRUCCIONES DE INSTALACION PASO A PASO (cont.)Seleccione la ubicaciónSeleccione una ubicación para el filtro que esté: protegida de la congelación.

Page 4 - PARTS LIST

No. de ref. Parte No. Descripción003 WHTIMER Sincronizador 1004 WS03X10054 Anillo 1006 HDWRNCH Llave de rosca 1007 FXHTC Elemento del filtro: Filtro d

Page 5

2Filter Cartridge ReplacementYou should change your filter when the water flow is noticeably reduced or at least every 3 months.Turn off water to filt

Page 6

3STEP-BY-STEP INSTALLATION INSTRUCTIONS (cont.)Select LocationSelect a location for the filter that is: protected from freezing. not exposed to dire

Page 7

4Ref. No. Part No. Part Description003 WHTIMER Timer 1004 WS03X10054 O-Ring 1006 HDWRNCH Canister Wrench 1007 FXHTC Filter Element—Carbon Filter —FXHS

Page 8 - LISTE DES PIÈCES

Consulter le service local des travaux publics au sujet des codes deplomberie. L’installation du système de filtration d’eau pour servicerigoureux d

Page 9

6Remplacement de la cartouche de filtrationOn doit changer la cartouche de filtration lorsque le débit d’eau diminue sensiblement, et au moins à inter

Page 10

Pose des raccordsLes instructions sont destinées à l’installation des raccords sur la tuyauterie en cuivre. Si l’unité doit être installée sur tout au

Page 11

8Noderepérage Pièce noDescription003 WHTIMER Minuterie 1004 WS03X10054 Joint torique 1006 HDWRNCH Clé pour absorbeur 1007 FXHTC Élément de filtre : au

Page 12 - LISTA DE PARTES

HERRAMIENTAS QUE SE NECESITAN Y ACCESORIOS PARA LA INSTALACION 2 llaves ajustables Cortador de tubos Regla o cinta métrica Taladro inalámbrico Lima Pa

Commentaires sur ces manuels

Pas de commentaire