Choice ALERTChoice ALERT™Control all sensors, accessories and remote transmitters from one location™Wireless Alarm SystemPanic ButtonUser’s Manual
1011To Replace a Panic Button If the Panic Button is lost or broken, you can either replace it with another Panic Button or remove it completely from
1011Description Battery Type Battery Life*Control Center (4) “AAA” 24 monthsPanic Button (1) “2032” 24 months*maximum potential life b
1213FCC WarningAny unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal la
1213WARNING!Risk of personal injury- Prolonged exposure to alarm siren may cause permanent hearing lossBattery Warnings!- Remove batteries before stor
14WARNINGLimitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly, m
14 is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City,
23Important Safeguards 4Introduction 5Activating the Battery 6Assigning a Panic Button to a Device Location 6Placement of the P
23Before connecting or operating the Panic Button, please read these instructions carefully and save this manual for future reference.CongratulationsT
45Important safeguardsPreCautions1. Do not attempt to disassemble the Panic Button, unless described in the user’s manual. There are no user serviceab
45IntroductionThe Panic Button is designed to be used indoors. When mounted properly in bedrooms, entrances, living rooms, family rooms or workshops i
67Activating the BatteryThe Panic Button is packaged with the battery installed, but not activated. To activate the battery, you must remove the yell
673. Press and hold the Panic Button. The Control Center will sound a long beep and the LED will stop flashing. Release the Panic Button. This confirms
89Mounting the Panic Button onto a Wall (using screws/wall anchors) – you will need drill, 3/16” or 1/8” drill bit and a flat blade-type screwdriver.
893(b). If mounting into a stud or wood surface, use a 1/8” drill bit, drill holes. Align mounting plate holes to drilled holes, insert screws and scr
Commentaires sur ces manuels