GE JGP985 Manuel d'utilisateur télécharger pdf (Page 21)

INSTALLING CABINETS OVER

YOUR COOKTOP

Avoid placing cabinets above the cooktop unit,

if possible, in order to reduce the hazards caused

by reaching over heated surface units.

If the cabinets are installed above the cooktop,

allow a minimum 30″ (76.2 cm) clearance

between the cooking surface and the bottom

of the cabinet.

A non-combustible material must be installed on

the under side of the cabinet. Use a flame retardant

millboard at least 1/4″ (6.3 mm) thick, or gypsum

board at least 3/16″ (4.7 mm) thick, covered with

28 gauge sheet steel or 0.020″ (.5 mm) thick

copper. The maximum depth of cabinets above

the cooktop is 13″ (33 cm).

EXCEPTION: Installation of a listed microwave

oven or cooking appliance over the cooktop shall

conform to the installation instructions packed

with that appliance.

Working areas adjacent to the cooktop should have

an 18″ (45.7 cm) minimum clearance between the

countertop and the bottom of the cabinet. If the

clearance is less than 18″ (45.7 cm), the adjacent

cabinets should be at least 8″ (20.3 cm) from the

side of the cooktop.

Installation Instructions

MINIMUM SPACING REQUIREMENT

When installing a double bay downdraft cooktop

in combination with another downdraft cooktop,

maintain the minimum spacing between units as

shown below. Installing them too close will affect

cooking performance.

25″

(63.5 cm)

30″ min

(76.2 cm)

30″

(76.2 cm)

13″

(33 cm)

18″

(45.7 cm)

8″ min to wall

(20.3 cm)

8″ min to wall

(20.3 cm)

36″

(91.4 cm)

18″

45.7 cm

⁄8″

11.1 cm

PREPARATION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

GE JGP985 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Barbecues et grillades GE JGP985