GE BT Series Guide d'installation télécharger pdf (Page 3)

Swing the hanging part of the shroud to the other

side of the two crossbars and latch the slots. Align the

4 slotted holes of the shroud and put the four white

screws in to the pre drilled holes in the crossbar – do

not tighten the screws yet.

Catch the slots of both corners of the shroud to the

crossbars, using caution not to bend the shroud. The

shroud can now hang freely.

Push the shroud from the bottom so that it is tight

against the ceiling. While holding the shroud, tighten

the four white screws, one at a time. The torque for the

four screws (SCR832X12PHPTFW) is between 6 and 10

in-lbs. Adjust as necessary for an even look.

IND146-102814

GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand, logo, and Lumination are trademarks of the General Electric Company.

Slot

Insert screw in 4 corners - do not tighten yet

Shroud

Attach UL approved conduit (rigid or exible per installation method) to the knockout of the power supply box. Connect the AC line

to the black (line) and white (neutral) input wires of the LED Driver using 18-14AWG twist-on wire connectors. Replace electrical

enclsoure cover.

For BT22 Series: Connect the ground wire to the green grounding wire.

For BT14 & BT24 Series: Connect the ground wire to the green grounding wire and driver grounding wire.

BT22 Series BT14 & BT24 Series

AC line

Ground wires

AC line

Ground

1 2 3

Commentaires sur ces manuels

Pas de commentaire

GE BT Series Guide d'installation Page 3

Commentaires sur ces manuels