Ge PROFILE PDW7000 Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
o
■S
O
3
b
to
c
V)
C
to
Caring for the dishwasher.
Cleaning the Control Panel
To clean the control panel, use a lightly
dampened cloth. Then dry thoroughly.
Protect Against Freezing
If your dishwasher is left in an unheated
place during the winter, ask a service
technician to:
rri Cut off electrical power to the
'—' dishwasher. Remove fuses or trip
circuit breaker.
Turn off the water supply and disconnect
'—' the water inlet line from the water valve.
Drain water from the water inlet line
'—' and water valve. (Use a pan to catch
the water)
[TH Reconnect the water inlet line to the
'—' water valve.
Check the dr gap any time your
dishwasher isn't draining well.
Does Your Dishwasher Have an Air Gap?
An air gap protects your dishwosher The air gap is easy to clean.
against water backing up into it if a drain
clogs. The oir gap is not a part of the
dishwasher. It is not covered by your
worronty. Not all plumbing codes require
air gaps, so you may not have one.
a
Turn off the dishwasher and lift off the
cover
rpl Remove the plastic cap and dean with
'—' a toothpick.
Before you call for service...
©
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit www.geappliances.ca. You may not need to coll for service.
Error Messages Possible Causes What To Do
START/RESET status You have pressed the
indicator light flashing START/RESET pad while the
dishwasher is running. This will
cancel the cycle. The light will
stop flashing after the dishwasher
droins (about 90 seconds).
Press the START/RESET pad once to start the dishwasher. Press the
START/RESET pad a second time when the dishwasher is running only if you
wish to cancel the cycle.
Power to the dishwasher was '
turned off while a cycle was
running and power has just been
restored to the dishwasher. The
blinking lights indicate that the
dishwasher is draining the potential
water inside.
The light will stop flashing after the dishwasher drains. A new cycle will
start automatically.
Dishwasher BEEPS This is a reminder that your
once every 30 seconds dishwasher door has been left
open during operation. It will
continue beeping until you close
the door.
Close and latch the door after opening it mid-cycle.
12
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire