Ge ZV925 Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
Саге and Cleaning
Glass Canopy Hood
For your
safety
Before servicing or cleaning the unit, switch
power off at the service panel and lock the service
panel to prevent power from being switched on
accidentally. If the service panel cannot be locked,
fasten a tag or prominent warning label to the
panel
Metal
grease
filter
The metal filter traps grease released by foods
on the cooktop. The filter also helps prevent flames
(from food, grease) from damaging the inside of the
hood.
For this reason, the filter must ALWAYS be in place
when the hood is used. The grease filter should be
cleaned every 6 months, or as needed.
To remove:
Grasp the filter lock and pivot it open to release.
Pull the filter down and out.
To replace:
1. Place the two tabs on the filter edge into the
locating slots in the left or right side of the hood
opening,
2. Push the filter up, open the filter lock and snap it
into place in the hood.
To clean, swish the filter in hot soapy water and
rinse in clean water or wash it in the dishwasher.
Do not use abrasive cleansers.
Charcoal filter
(on some models)
If the model is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 5 to 12
months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filter in an
automatic dishwasher.
The charcoal filter cannot be cleaned. It must be
replaced.
Order Charcoal Filter WB02X11269.
To inquire about purchasing replacement charcoal
filters or to find the location of a dealer nearest you,
please call our toll-free number:
National Parts Center 800.626.2002
To remove:
1. Remove the metal filter—see Metal grease filter
section above.
2. Remove the two thumbscrews and lower the
filter down and out.
To replace:
1. Place the new filter over the filter mounting bolts
in the hood and secure with the thumbscrews.
2. Replace the metal filter—see Metal grease filter
section above.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire