Ge JGP328 Manuel d'utilisateur télécharger pdf (Page 15)

15

LP Conversion

F4

Adjusting the Burners,

Low Flames

a. Turn all burners full on and check the flames.

They should be blue in color with no trace of

yellow. Foreign particles in the gas line may

cause an orange flame at first, but this will

soon disappear.

b. Turn the control valve to low position while

observing the flame.

c. To make adjustment, remove the control

knobs. Insert a screwdriver through access

hole in valve switch. Engage adjustment

screw in valve.

Adjust the low flame setting using the valve

bypass screw as follows:

Low setting adjustments must be made with

two other burners in operation on a medium

setting. This prevents the low flame from being

set too low resulting in the flame being

extinguished when other burners are turned on.

f. Flame Recheck:

After the adjustment is made, turn all burners

off. Ignite each burner individually. Observe the

flame at the “HI” position. Rotate the valve to

the “LO” position and be sure that the flame

size decreases as the valve is rotated

counterclockwise.

• If the flames were too small or fluttered,

open the valve more than the original setting.

• If the flames blew away from the burner,

close the valve more than the original setting.

d. Make the adjustment by slowly turning the

screw until flame appearance is correct.

e. Testing Flame Stability:

Test 1 - Turn the knob from “HI” to “LOW”

quickly. If the “LOW” flame goes

out, increase the flame size and

test again.

Test 2 - With the burner on the “LOW”

setting, open and close the cabinet

door under the cooktop. If the

flame is extinguished by the air

currents created by the door

movement, increase the flame

height and test again.

TO CONVERT THE COOKTOP BACK TO

NATURAL GAS, REVERSE THE STEPS

UNDER MAKING THE LP CONVERSION.

Once the conversion is complete and

checked ok, fill out the LP sticker and

include your name, organization and date

conversion was made. Apply the sticker

near the cooktop gas inlet opening to alert

others in the future that this appliance has

been converted to LP gas. If converting

back to natural gas from LP, please

remove the sticker so others know the

appliance is set to use natural gas.

HIGH OUTPUT

Making the L.P. Conversion cont.

F

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Commentaires sur ces manuels

Pas de commentaire