Ge JV960SCBR Manuel d'utilisateur télécharger pdf (Page 5)

6. Open the filter panel.

Pull the visor slides out. Rotate the panel clips and

swing the panel open.

7. Install the mounting brackets.

Hold the left hand mounting bracket in place on

the side of the housing as shown.

Two (2) sets of screws are provided. Use the short screws

for flush bottom cabinets or long screws for recessed

bottom cabinets. Insert two (2) screws through the

housing and into the mounting bracket. Do not tighten

screws completely.

INSTALL THE HOOD

1. Mark and cut out the cabinet bottom.

Prepare the cabinet bottom as shown above. Be

sure to locate the cut-out and four holes from the

front of the cabinet to ensure a flush mount.

2. Attach the damper/duct connector.

Use two (2) screws (provided) to attach the connector

to the housing. The damper flap should open in the

direction indicated by the arrow.

3. Remove the electrical knockout.

Choose either the top or side of the housing for the

electrical cable entrance. Remove the appropriate

knockout.

4. Set the housing into the opening.

Carefully lower the housing into the cabinet opening

with the slide control to the front.

5. Remove the access cover.

INSTALLATION INSTRUCTIONS

FRONT

OF HOOD

VISOR

SLIDES

1 2 3 4 5 6 7 8

Pas de commentaire

Ge JV960SCBR Manuel d'utilisateur Page 5