GE ZDIC150 Manuel d'utilisateur télécharger pdf (Page 12)

Care and Cleaning

Icemaker

Condenser

For best performance, brush or vacuum lint and

dirt from the condenser once a year.

A dirty or clogged condenser:

• Prevents proper airflow.

• Reduces ice making capacity.

• Causes higher than recommended operating

temperatures which may lead to component

failure.

1. Unplug the icemaker or disconnect power.

2. Remove the 2 screws in the lower access

panel and the 2 screws from the base grille

area of the front panel support. Pull forward

to remove the lower access panel.

3. Pull the bottom forward and then pull down

to remove the lower access panel.

4. Remove dirt and lint from the condenser fins

and the unit compartment with a brush

attachment attached to a vacuum cleaner.

5. Replace the lower access panel using the

4 screws.

6. Plug in the icemaker or reconnect power.

Icemaker

system

1. Press and hold OFF.

2. Wait 5 to 10 minutes for the ice to fall into the

storage bin. Remove all ice from the storage

bin.

3. Unscrew the drain cap from the bottom of the

water reservoir located inside the storage bin as

shown. Allow the water to drain completely.

4. Replace the drain cap.

5. Use the entire 16 oz. bottle of Nickel Safe

Ice Machine Cleaner rather than the amount

suggested on the bottle. Follow all safety

precautions on the bottle. Pour one bottle of

solution into the water reservoir. Fill the bottle twice

with tap water and pour it into the water reservoir.

Nickel Safe Ice Machine Cleaner by Nu Calgon

is available at appliance repair shops, or through

GE Parts and Accessories. Order part number

WX08X42870. In the U.S.A., call 800.626.2002 or visit

monogram.com. In Canada, call 1.888.880.3030.

6. Press and hold CLEAN. The CLEAN light will

begin to blink, indicating that the cleaning

cycle is in process. The cleaning time is

approximately 70 minutes.

7. When the indicator light becomes solid and

remains lit, the cleaning cycle is complete.

During the cleaning cycle, the system will

both clean and rinse itself.

8. After the cleaning cycle is complete, remove

the drain cap from the water reservoir to see

if any cleaning solution, green in color, is left in

the water reservoir. If cleaning solution drains

from the water reservoir, you should run the

clean cycle again. Be sure to replace the drain

cap before running the cycle again. If the cap

is not securely tightened, water can leak,

causing thin ice or no ice.

NOTE: Severe scale buildup may require repeated

cleaning with a fresh quantity of cleaning solution.

9. Press ON to resume ice production.

Water reservoir

Drain cap

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

GE ZDIC150 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons GE ZDIC150