Ge ZKD910SFSS Manuel d'utilisateur télécharger pdf (Page 7)

Installation Preparation

NOTE: Additional clearance between cutouts may

be required. Check to be sure that oven supports

above the Warming Drawer location does not obstruct

the required interior 23-1/2” depth and 9-1/4” height.

NOTE: Additional clearance between cutouts may

be required. Check to be sure that oven supports

above the Warming Drawer location does not obstruct

the required interior 23-1/2” depth and 9-1/4” height.

INSTALLATION OPTIONS

Dimensions

A B

ZTD910 28-1/2” 30”

ZKD910 25-1/2” 26-3/4”

When installed under a wall oven:

Warming drawers are approved for installation below only

certain specified wall oven models. See the label attached to

the top of the warming drawer for approved models.

• When installed, the front face of the drawer will be nearly

flush with adjacent cabinetry doors.

• Drawer overlaps will conceal cut edges on all sides of the

opening.

The rough opening for the drawer must be:

– Depth: 23-1/2” min. from inside back to front of cabinet

frame.

– Width: 25-1/2” for 27” wide models, 28-1/2” for 30” wide

models.

– Height: 9-1/4”.

– Allow 2” min. between oven and drawer cutouts for

clearance of overlaps.

NOTE: If you are installing in frameless cabinets, it may

be necessary to install 1/2” wide cleats to accept drawer

mounting screws. See drawer for mounting screw locations.

Installation Below

a Single Oven

Installation Below

a Double Oven

2x2 or 2x4 Anti-Tip

Block Against Rear

Wall, 9” From Floor

to Bottom of Block

1” Min. Above Toekick

Allow 5/8”

Overlap on

All Sides

23-1/2”

Min. Inside

Oven

Cutout

2” Min.

9”

9-1/4”

23-1/4”

10-1/2”

2x2 or 2x4 Anti-Tip

Block Against Rear

Wall, 9” From Floor

to Bottom of Block

1” Min. Above Toekick or Adjust

to Oven Installation Height