GE JVM2070_H Manuel d'utilisateur télécharger pdf (Page 9)

– 9 –

Microwave Removal and Component

Access

Note: Some components can be accessed

without removing the microwave. If the 2 end

screws on top of the outer cover are accessible

(

see illustration below), the hidden vent can be

removed without removing the microwave from its

installation.

Note: For easier removal and personal safety, it

is recommended that 2 people remove the

microwave.

Unplug the microwave and remove it from the wall

by removing three screws in the cabinet above

the microwave.

Lift the fan out of the microwave and disconnect

the electrical connector.

Remove the screw holding the fan in place.

Tilt the microwave forward and lift it off the lower

tabs of the rear mounting plate. Route the power

cord through the hole.

Place the microwave on a protected counter or

table.

To remove the cover, remove 2 screws from the

left side, 3 screws from the right side, 5 screws

from the top, 5 screws from the rear, and 2

screws from the bottom of the outer cover.

Open the microwave oven door. Slide the hidden

vent to the left and remove the hidden vent.

Exhaust Fan

Resistance through the exhaust fan from the

power cord (N) to CN03 pin 7 is approximately

28.7 ohms.

Removal

Remove the microwave (see

Microwave Removal

and Component Access). Remove the screw on

top of the microwave holding the exhaust adapter

in place, then slide the exhaust adapter to the rear

and remove.

Disconnect

Top View

Components

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

GE JVM2070_H Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes GE JVM2070_H