Ge Feb-50 Manuel d'utilisateur télécharger pdf (Page 9)

E. Connect a LONG TELEPHONE LINE CORD to the

jack on the back of the telephone labelled LINE 3-4.

Connect the other end to wall jack(s) labelled 3 & 4 \n

the same manner described above.

F. Connect either end of the COILED CORD to the jack

on the side of the TELEPHONE BASE UNIT. Connect

the other end to the jack in the HANDSET. Place the

HANDSET in the cradle.

G. Plug the AC POWER SUPPLY CORD into the jack on

the telephone labelled DC 9V. Thread the cord behind the

STRAIN RELIEF. Plug the AC POWER SUPPLY into

the nearest electrical outlet.

H. After you plug in the AC POWER SUPPLY you should

see the INTERCOM LED flash red and green.

Consult the WORKSHEET above to see which Station

Number you have assigned to this telephone. Press

that same number on the MEMORY/INTERCOM IN

DEX. The phone will beep, and the LED will start

flashing red as it checks to see if this station address

is already in use. If this station address is not already

in use, the LED will turn off and the telephone will

automatically conduct a “line check”. During the “line

check” the line LED’s for each line connected will

turn green. After a few seconds all LEDs will go off

and you will here 3 beeps and the telephone should

be fully functional.

NOTE: If you hear an error tone, the intercom number

you pressed has already been assigned to another

station or the TELEPHONE LINE CORDS are not pro

perly connected. Check the LINE CORD connections.

Check the station number assignments on your

worksheet and repeat the procedure. (If you need to

change the address of a station, refer to page 28 in

the Use and Care Guide)

. If you desire, you may turn off the ringer for any line

or lines at any station. Press the STORE button and

you should see a red LED for each LINE button. The

LED indicates the line is active and will ring. To

disable a ringer press these buttons in the sequence

to the right:

The LED should turn off, indicating a disabled ringer.

Repeat this sequence for each ringer you wish to

disable.

To turn a ringer back on: See page 23 of the

accompanying USE AND CARE GUIDE.

Note: For complete information on the programming and use of

your GE Model 2-9450 telephone, consult the accompanying USE

AND CARE GUIDE.

TO DISABLE

RINGER

PRO

E«0

STOHOm

PRO

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ge Feb-50 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Téléphones Ge Feb-50