Ge ZIC30GNDII Manuel d'utilisateur télécharger pdf (Page 18)

Installation Instructions

STEP 11 ATTACH HINGE GUARD

WARNING:

This appliance must be installed & operated with the

hinge guard in place !

1. Tape hinge guard cover to side of case. Align cover

with top and front edges of case.

2. Attach hinge guard by sliding flat part between case

and hinge guard cover.

3. Fasten guard to door front using 4 screws.

STEP 9 REVERSE DOOR SWING (cont).

14. install screws on the bottom hinge next.

15. Using a Torx T-20 wrench, tighten the tension on

the hinge springs by turning the screws from 0 to

13. With another person holding the door in place,

align the holes in the door hinge bracket with the

holes in the hinge. Install the screws to the top

hinge first.

Door

Screws

Use Torx

T-20 Wrench

STEP 10 ADJUST DOOR SWING (if needed)

NOTE: This refrigerator has a 2-position door stop. When

space does not allow the door to swing to 115°, you may

limit the door swing to a 90°

Skip this step if door opening is satisfactory for your

installation situation.

• Open the fresh food door to access the top and bottom

hinges.

• Loosen the bottom hinge screws that attached to the

unit

• Pull hinge forward slightly & insert hinge pin into the

hole nearest the unit.

• You may need to use a small hammer to fully seat

them in place.

• Retighten hinge screws.

• Repeat for top hinge.

Install 1 pin,

per hinge for

90° door stop.

Hinge screws

Cover

Hinge guard

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ge ZIC30GNDII Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Ge ZIC30GNDII