GE TUN Guide d'installation télécharger pdf

GEH-3926D

INSTRUCTIONS

Tunnel Guard

™

Luminaire

Installation and Maintenance

READ THOROUGHLY BEFORE INSTALLING

CAUTION: Hold the luminaire firmly to keep it from

swinging when the latches are released.

Reverse the above steps for mounting the luminaire.

B. RECESSED MOUNTING: (Figure 2)

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

GENERAL

This luminaire is designed for tunnel lighting

applications, and should not be used in high ambient

temperature enclosures; it should be installed and

maintained according to the following recommendations.

UNPACKING

This luminaire has been properly packed so that no parts

should have been damaged during transit. Inspect to

confirm.

INSTALLATION MOUNTING:

Figure 1

Two types of mounting are available for this luminaire:

A. SURFACE MOUNTING: (Figure 1)

Install luminaire (A) using the slots provided on the

mounting plate (B).

NOTE: Orient the luminaire with the traffic flow

according to the direction label provided on its

surface.

NOTE: To remove the luminaire from the mounting

plate release the two (2) large latches (C). Gently

swing the luminaire away from the plate, then lift it

out from the quick-release hinges (D).

Figure 2

Install luminaire (A) using the slots provided on the

mounting plate (B).

NOTE: Orient the luminaire with the traffic flow

according to the direction label provided on its

surface.

WIRING

Figure 3

MAKE ALL ELECTRICAL CONNECTIONS IN

ACCORDANCE WITH THE NATIONAL ELECTRICAL

CODE AND US COAST GUARD REQUIREMENTS CFR

46 SECTION 110 THROUGH 113.

CAUTION

Risk of burn

• Do not touch operating luminaire

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2

Résumé du contenu

Page 1 - Installation and Maintenance

GEH-3926DINSTRUCTIONSTunnel Guard™ LuminaireInstallation and MaintenanceREAD THOROUGHLY BEFORE INSTALLINGCAUTION: Hold the luminaire firmly to keep it

Page 2 - MAINTENANCE

Verify that supply voltage is correct by comparing itto nameplate.NOTE: On units with power cord attached:a) If the lamp is already installed go direc