GE 25450 Manuel d'utilisateur télécharger pdf (Page 111)

Base Unit Battery

NOTE: Only use the same type of Nickel Metal Hydride (Ni-MH ) battery that was originally

supplied .

1. Make sure the telephone is OFF before you replace battery.

2. Remove the battery compartment cover.

3. Disconnect the cord attached to the battery pack from the jack inside the battery

compartment and remove the battery pack.

4. Insert the new battery pack and connect the plug on the battery pack to the jack

inside the compartment.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the

compartment. To ensure proper battery installation, the connector is keyed and can be

inserted only one way.

5. Close the battery compartment cover.

NOTE: Allow the Base Unit battery to properly charge (for 12 hours) prior to ﬁrst use or when

you install a new battery pack. If you do not properly charge the phone, battery performance

will be compromised.

Battery Safety Precautions

• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this type,

toxic materials could be released which can cause injury.

• To reduce the risk of ﬁre or personal injury, use only the battery listed in the

User’s Guide.

• Keep batteries out of the reach of children.

• Remove batteries if storing the Base Unit or Cordless Handset over 30 days.

Settings and Adjustment

Battery

Batter

Com

artment Cover

Black Wire

111

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 123 124

Pas de commentaire

GE 25450 Manuel d'utilisateur Page 111