Ge 10 AZA Manuel d'utilisateur télécharger pdf (Page 15)

Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support

Install the Case in the Window

Peel off the backing from the bottom

window gasket.

Place the gasket on the stool and over the

brackets, even with the rear edge, sticky

side down.

Carefully slide the empty case into the

window until the holes in the case line up

with the holes in the panel angles.

NOTES:

■ The case should have a 1/8″ minimum tilt

toward the outside.

■ Be sure the seal gasket and panel gaskets

remain in position and do not roll with the case.

Lower the window so it fits behind the panel

tabs. Insert the 4 type A screws through the

holes in the case and into the panel angles,

2 on each side.

With the window closed, mark where the

window sash meets the case.

Peel off the backing from the case top gasket.

Hold on to the case, open the window, and

place the gasket along the mark on the case.

Place the vinyl window gasket over the case

top gasket. Insert the panel tabs through the

slits in the gasket. Cut the gasket on each side

to the width of the window.

Close the window tightly on the vinyl gasket.

Bend the gasket forward to expose the panel

tabs. Drill pilot holes into the window sash.

Bottom window gasket

Case holes

Panel

tabs

Case

screws

Put the gasket on top

of the case where the

window will close.

Panel

tab

Vinyl window

gasket

Attach the panel tab to

the window on each side

with a type D screw.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ge 10 AZA Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Adoucisseurs Ge 10 AZA