Ge ZET2S Manuel d'utilisateur télécharger pdf (Page 26)

Self-Cleaning Oven

Wall Oven

Before a

clean cycle

The oven door must be closed and all controls

must be set correctly for the self-clean cycle to

work properly.

We recommend venting your kitchen with

an open window or using a ventilation fan

or hood during the first self-clean cycle.

• Clean soil from the frame around the oven

door and outside the door gasket. These

areas must be cleaned by hand.

• Do not clean the door gasket by hand as this

could damage it.

• Wipe up excess grease and other food spills

with a damp cloth. This will minimize the

amount of smoke created during self-

cleaning.

• Remove all cookware, broiler pan, grid, probe

and any aluminum foil from the oven.

• The oven racks may be left in the oven during

the self-clean cycle.

• Make sure the oven light lens and lens frame

are in place.

• Do not use commercial oven cleaners,

abrasives or oven protectors in or near the

self-cleaning oven.

IMPORTANT: The health of some birds is

extremely sensitive to the fumes given off

during the self-cleaning cycle of any oven.

Move birds to another well-ventilated room.

NOTE: Self-Clean will not work if the

temperature probe is plugged in or if the

Sabbath feature is set.

On double oven models, you can set a clean cycle

in both ovens at the same time. The last oven set will

automatically delay its start until the end of the first

oven’s clean cycle.

On double oven models, you can use timed baking in

one oven and self-clean in the other at the same time.

Turn the Oven Mode knob to CLEAN.

Turn the Temperature knob to CLEAN.

The oven is set to clean for its normal clean

time of 5 hours. (If a clean time less than

5 hours is needed, turn the Mini-Knob to

the clean time desired.) Push to enter it.

You can change the clean time to any

time between 3 and 5 hours, in 15 minute

increments, depending on the amount of soil

in your oven.

NOTE: The Mini-Knob must be pushed for the

self-clean cycle to start.

If your oven is connected to a 208V electrical

supply, we recommend that you set your clean

time for 5 hours.

If LOCKED flashes in the display, the self-clean

cycle has been selected but the door is not

closed. Close the oven door.

The display will show CLEAN and the clean

time remaining.

As the oven heats to the clean temperature,

the door will lock automatically. The LOCKED

light will turn on. The display will show the

clean time remaining. It will not be possible

to open the oven door until the temperature

drops below the lock temperature and the

LOCKED light goes off.

After the clean cycle is complete and

the oven has cooled, END will show in the

display and the LOCKED light will turn

off. Turn the Oven Mode knob and the

Temperature knob to OFF.

To stop a clean cycle, turn the Oven

Mode knob and the Temperature knob

to OFF. When the LOCKED light goes off,

indicating the oven has cooled below the

locking temperature, you will be able

to open the door.

How to set

the oven for

cleaning

Oven Mode knob Temperature knob

Mini-Knob

Turn to select

Push to enter

Double oven display shown.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 127 128

Commentaires sur ces manuels

Pas de commentaire

Ge ZET2S Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Fours à convection Ge ZET2S