GE JN327 Manuel d'utilisateur télécharger pdf (Page 10)

REMOVE EXHAUST ADAPTOR

If exhausting/venting using the 3

⁄4″ x 10″ rectangular

duct—optional for JV338, JV347, JV348 and JV367

models only:

Remove the exhaust adaptor from the inside of the

hood. Set it aside along with its mounting screws.

⁄4″ x 10″

rectangular

exhaust

adaptor

and screws

REMOVE FILTER

Remove the shipping tape holding the metal grease

filter in place. Pull down on the center of the front

edge of the filter. The filter will then slip out of the

retaining tabs on the back.

REVERSE THE BAFFLE FOR

DUCTED INSTALLATIONS ONLY

(JV347, JV348 and JV367 models)

If the hood is to be recirculated, skip to the next step.

Remove the baffle from the top of the hood. Re-install

the baffle so the short side marked “VENTED” is

visible. The long side of the baffle should be inside

the hood.

REMOVE WIRING COVER

Remove the wiring cover from inside the hood.

Set the cover and its mounting screw aside.

Wiring

cover

REMOVE WIRING KNOCKOUT

Remove either the top or the back wiring knockout as

needed and install an approved strain relief clamp.

Strain relief

clamp

Metal grease filter

Installation Instructions

Back knockout

Top knockout

“VENTED” is visible

Strain relief

clamp

REMOVE DUCT KNOCKOUT

If recirculating, non-vented ductless (JN327 and RN328,

and optional for JV347, JV348 and JV367 models only),

skip to Step 10 D and proceed.

Using a flat blade screwdriver, remove the appropriate

duct knockout from the top or back of the hood.

⁄

″ x 10″ Rectangular

vertical discharge.

Remove top rectangular

duct knockout only.

7″ Round vertical

discharge. Remove circular

duct knockout only.

⁄

″ x 10″ Rectangular

horizontal discharge. Remove

rear rectangular duct knockout only.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

GE JN327 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JN327