GE JV327 Manuel d'utilisateur télécharger pdf (Page 7)

3. POWER SUPPLY

A. CIRCUIT VOLTAGE: This hood must be connected

to a supply circuit of the proper voltage and frequency

as specified on the rating plate. Wire size must conform

to the requirements of the National Electrical Code or

the prevailing local code for hoods of this rating. The

rating plate is located on the rear wall of the hood.

B. FUSE RATING: 15 amps.

C. Unless otherwise specified by local codes, bring

a 15 amp 2 wire circuit with ground to the area of

the power supply connection box.

D. USE OF OPTIONAL TOP POWER SUPPLY:

The power supply can be attached through the top

knockout if desired, but only the top or back knockout

shall be opened (See Figs. 8, 9 and 10).

4. HOOD INSTALLATION

A. MECHANICAL

NOTE: When possible, it is more convenient to mount

and wire the hood before the base cabinet is put in place.

1. Take out 1 screw and remove the power supply

connection box cover located on the underside

of the hood (See Fig. 13 Model: JV327) (See Fig. 12

Models: JN327, JV337 & JV347).

2. To locate the 4 mounting holes, position the hood

carefully against the bottom of the wall cabinet and

mark the screw positions through the keyhole slots

in the hood. Drill 3/32″ pilot holes for the mounting

screws in the small end of the keyhole.

3. Partially drive the 4 mounting screws so that the

heads of the screws extend 1/2″ below the bottom of

the cabinet. Raise the hood against the bottom of the

cabinet, making sure that the heads of the mounting

screws protrude through the hole section of the

keyhole slots as shown in Fig. 11. Before tightening

the mounting screws, attach the power supply cable

to the hood. Then push the hood back against the

wall and tighten the mounting screws.

Exhaust outlet connects to 3

⁄4″ x 10″ rectangular duct; outlet has TOTAL

ADJUSTMENT of 1

⁄2″ from side to side to simplify duct alignment.

NOTE: Exhaust outlet can

be installed as either TOP

or REAR by removing

desired knockout. Insert a

screwdriver under edge of

knockout. Break tabs and

remove knockout with pliers.

Power supply

entrance openings

in top and rear of hood.

NOTE: Use of REAR opening

is recommended.

⁄4″

FIGURE 10

FIGURE 8

FIGURE 9

FIGURE 11

Direction of

movement for mounting

Screws

Keyhole

slots

Centerline of hood

Power

supply entrance

openings in top

and rear of hood.

NOTE: Use of REAR opening

is recommended.

Power supply

entrance openings

in top and rear of hood.

NOTE: Use of REAR

opening is recommended.

Exhaust outlet connects to 7″ dia. duct.

Centerline of hood

Top exhaust

outlet only

⁄4″

1″

1/2″

3/4″

Center line

Center

line

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

GE JV327 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JV327