GE JV535 Manuel d'utilisateur télécharger pdf (Page 14)

TROUBLESHOOTING CHECKLIST

If the hood seems to be operating at high speed when

the control is not set on high, or if ventilation seems

inadequate, check the following:

❏ Knockouts not removed from hood.

❏ Damper blade not opening.

❏ Reduced airflow because the duct is too small or the

duct length is too long.

❏ The duct is blocked.

❏ Undersized or restrictive wall or roof cap.

REPLACE WIRING COVER

On models so equipped, replace the wiring cover or

the bottom cover.

SECURE HOOD

Slide the hood back against the wall. Tighten

the mounting screws. Be sure the screw heads

are in the narrow neck of the keyhole slot.

Keyhole (4)

Mounting

screw (4)

NOTE: DO NOT PUSH ON FAN BLADE. Pushing

on the blade may cause it to interfere with other

hood parts.

FOLLOW ELECTRICAL CODE

Complete the electrical wiring according to

National Electrical Code and local codes.

NOTE: This hood must be permanently grounded.

Connect house wiring (120 VAC) to hood wiring.

CONNECT WIRING

Connect house black to hood black wire, house

white to hood white wire, and house ground under

green ground screw. Securely tighten the strain

relief clamp onto the house wiring.

Green ground screw

INSTALL LIGHT BULBS

Purchase and install two PAR20, 50 W maximum

halogen bulbs.

CONNECT DUCTWORK TO

HOOD

Use duct tape to make joints secure and air tight.

Duct tape

REPLACE FILTERS

Make sure fan blade turns freely. The installation is

complete. Turn on power at service panel, and test

for proper operation.

Installation Instructions

1 2 ... 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

GE JV535 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JV535