GE JV696 Manuel d'utilisateur télécharger pdf (Page 5)

7. Install the mounting brackets.

Hold the left hand mounting bracket in place on

the side of the housing as shown.

Two (2) sets of screws are provided. Use the short

screws for flush bottom cabinets or long screws for

recessed bottom cabinets. Insert two (2) screws

through the housing and into the mounting bracket.

Do not tighten screws completely.

Insert two (2) screws, short or long as appropriate,

through the control box and into the other mounting

bracket. Do not tighten the screws completely.

2. Attach the damper/duct connector.

Use two (2) screws (provided) to attach the connector

to the housing. The damper flap should open in the

direction indicated by the arrow.

3. Remove the electrical knockout.

Choose either the top or side of the housing for the

electrical cable entrance. Remove the appropriate

knockout.

4. Set the housing into the opening.

Carefully lower the housing into the cabinet opening

with the slide control to the front.

5. Remove the access cover.

6. Open the filter panel.

Pull the visor slides out. Rotate the panel clips

and swing the panel open.

INSTALLATION INSTRUCTIONS

FRONT

OF HOOD

VISOR

SLIDES

PANEL

CLIP

1 2 3 4 5 6 7 8

Pas de commentaire

GE JV696 Manuel d'utilisateur Page 5