GE JV936DSS Manuel d'instructions télécharger pdf (Page 14)

13-1/16"

1/4"

Gap

Installation Instructions

1 INSTALL HOOD SUPPORT

IMPORTANT: Framing must be capable of

supporting 100 lbs.

• Locate at least 2 vertical studs at the wood mounting

location by tapping drywall with a hammer or use a

stud finder.

• Center the supplied wood horizontal support, left to

right and below the marked line.

• Drill 1/8 pilot holes through the support, drywall

and into the studs. Secure the support to 2 or more

vertical studs with supplied wood screws.

IMPORTANT: Screws must penetrate at least 1-1/2

into vertical studs. Countersink screws into support.

• Install mounting screws in the center of the wood

support, 13-1/16 from the centerline. The screws

should protrude forward 1/4 . This 1/4 gap will

provide clearance to hang the hood.

2 INSTALL TRANSITION

• Place the transition piece over the hood exhaust.

Secure transition to hood with 4 screws provided.

• Use duct tape to seal the connection.

3 INSTALL HOOD ONTO WALL

• Lift the hood and place over the wood support.

The top keyhole slots in the hood should engage

the protruding mounting screws. Allow the hood

to slide down into position.

• Pull house wiring through knockout at the rear or

the top of the hood.

• Check to be sure the hood is level and centered. The

arrow shaped cutout in the back of the hood allows

viewing the marked centerline.

• Remove cover from junction box.

Drill Bottom Mounting Hole Locations

• Drill 1/8 pilot holes into the two lower mounting

holes. Enlarge the holes if they did not enter studs to

3/8 . Tap anchors for wall fasteners into bottom holes.

Install screws by hand into the fasteners to allow

anchors to expand against the wall. Remove screws.

• Using two large flat washers (supplied), install wood

screws or wall fastener screws, loosely, into lower

mounting holes. Do not tighten.

• Check hood level. Tighten upper screws. Tighten

lower mounting screws.

• For additional security, drive screws through the

original wood support screw holes in the back of

the hood.

Centerline of

Installation

Space

7" Min. Opening for Ductwork

15-3/8"

24"

36"

Wood

Support

Duct

Transition

Top of

Hood

Remove

Shipping

Tape on

Damper

Centerline of

Installation

Space

24"

36"

Cutout

IMPORTANT: Remove

shipping tape from

damper and check that

damper moves freely.

″

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

GE JV936DSS Manuel d'instructions Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JV936DSS