GE JVW5361SJSS Manuel d'instructions télécharger pdf (Page 7)

31-10983

Installation Instructions

Non-vented (recirculation) Installations

NOTE: Recirculation duct (included) and charcoal

filters JXCF72 (not included) are required. The

damper is not installed on the unit with

recirculation installations.

1. Install the non-vented (ductless) recirculation

duct (A) supplied with the vent hood.

Non-vented (recirculation) Installations

(Continued)

2. Check that the recirculation duct is in the correct

orientation with the hole towards the front of

the hood. Fit the recirculation duct over the vent

exhaust outlet (B) and push down to seat on the

outlet.

3. Go to Mount the Range Hood in this section.

PREPARE HOOD FOR INSTALLATION

1. Remove the grease filters from the unit and

set aside. The grease filters are removed

by pressing the handle

in front of the filter.

When replacing, make

sure that the filters are

properly positioned with

the handles in front and

visible.

2. Remove and properly discard the protective

plastic wrapping from the hood and grease

filters.

3. Remove junction box cover.

Vented Installations

1. Securely press damper on top of the exhaust

opening. Check that the damper opens freely.

2. Go to Mount the Range Hood in this section.

INSTALLATION INSTRUCTIONS

NOTE:

Hole must

be facing

toward front

of hood.

MOUNT THE PYRAMID RANGE HOOD

1. Install the range hood body by placing the

hood key holes over the mounting screws. Feed

the power supply cable through the electrical

knockout. Tighten the mounting screws.

2. Insert 2 mounting screws into the 2 duct cover

anchors (installed on line D in Preparing the

Wall section) located in the slots on the back

surface of the hood. Secure tightly.

3. Connect the house ducting to the damper

on the hood body if ducted install. Seal all

connections with duct tape.

NOTE: If recirculation installation, skip to Step 4

and proceed.

4. Install the upper duct cover.

Slightly spread the sides of

the cover apart and hook

them behind the duct cover

mounting brackets. Attach

the cover to the brackets

with 4 duct cover screws.

Mounting

Screw Slots

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

GE JVW5361SJSS Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JVW5361SJSS