GE PV976NSS Manuel d'instructions télécharger pdf (Page 19)

INSTALL DUCT BRACKET

AND DEFLECTOR

The duct bracket should be installed against the back

wall and flush with the ceiling; the point where the

ceiling meets the wall should be level for the bracket

and duct cover to fit flush. This bracket will hold

the duct cover in place at the top.

Secure the bracket to the wall:

• Align the diamond centerline cutout on the bracket

to the penciled centerline on the wall.

• Mark 2 screw hole locations in the wall.

• Drill 1/8" pilot holes in the marked locations.

• If pilot holes do not enter wood studs, enlarge

the holes to 3/8" and install metal wall fastener

anchors (provided).

• If mounting directly to a masonry wall, obtain

appropriate #10 masonry screw anchors. Drill

and install per the fastener supplier’s instructions.

• Drive screws, by hand, into the fasteners to allow

anchors to expand. Remove the screws.

• Secure the bracket to the wall with wood screws

and/or fasteners.

• Assemble the air deflector accessory to the duct

cover bracket with the 4 assembly screws provided.

DO NOT tighten screws. This is a temporary

installation.

Installation Instructions

INSTALL HOOD MOUNTING SCREWS

The mounting screws must enter the horizontal

support or wall studs.

• With the template taped in place, use a punch

to mark mounting bracket screw locations.

• Drill 1/8" pilot holes in 4 of the punched locations

in the lower bracket. If the bottom 2 pilot holes do

not enter wood, enlarge the holes to 3/8” and install

metal wall fastener anchors (provided).

• Remove the template.

• Install the 2 top mounting screws; leave 1/4" gap

between the screw head and the wall. This will allow

the keyhole slot on the hood frame to engage the

screw head.

IMPORTANT: Use the mounting screws provided.

DO NOT USE DRYWALL SCREWS.

• Check to be sure the mounting screws are

horizontally level.

Centerline cutout

REAR WALL

MOUNTING TEMPLATE

Ver

cal C

nterline

ALIGN BOTTOM EDGE

WITH PENCIL LINE

INDICATING BOTTOM

OF THE HOOD

11-7/16"

Installation Height

Horizontal Line

DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT

10-1/8"

12-08 JR

DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT

12-1/2"

WALL VENT IS 27-3/4" MIN.

ABOVE THE INSTALLATION

HEIGHT

31-14772 Printed in Mexico

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

GE PV976NSS Manuel d'instructions Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE PV976NSS