GE JBC17 Manuel d'utilisateur télécharger pdf (Page 30)

STEP 1

PREPARE THE OPENING

⁄

″ spacing is recommended from the range to

adjacent vertical walls above cooktop surface.

Allow 30″ minimum clearance between surface

units and bottom of unprotected wood or metal

top cabinet, and 15″ minimum between

countertop and adjacent cabinet bottom.

EXCEPTION: Installation of a listed microwave

oven or cooking appliance over the cooktop shall

conform to the installation instructions packed

with that appliance.

To eliminate the risk of burns or fire by reaching

over heated surface units, cabinet storage space

above the surface units should be avoided. If

cabinet storage is to be provided, the risk can be

reduced by installing a range hood that projects

horizontally a min. of 5″ beyond the bottom of

the cabinets. Make sure the wall coverings,

countertops and cabinets around the range can

withstand heat generated by the range, oven or

cooktop up to 200° F.

NOT LESS THAN

WIDTH OF RANGE

LOCATE

OUTLET BOX

WITHIN EITHER

SHADED AREA

INSTALL

OUTLET BOX

ON EITHER

SIDE OF C

OUTLET

BOX

5″ MIN.

⁄

″

MIN.

15″

MIN.

30″

MIN.

CORD

WALL

HOOD

FLOOR

7″

⁄

″

⁄

″

⁄

″

⁄

″

5″

⁄

″

C OF RANGE

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

IMPORTANT: Save these instructions for

the local electrical inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING

CODES AND ORDINANCES.

NOTE TO INSTALLER: Leave these

instructions with the appliance after

installation is completed.

NOTE TO CONSUMER:

Keep this Use and

Care Guide and Installation Instructions for

future use.

NOTE: This appliance must be properly

grounded.

TOOLS YOU WILL NEED

• Large blade screwdriver

• Channel lock pliers or small ratchet wrench

with 3/16″ socket (for leveling range)

• 1/4″ hex head nutdriver

ELECTRICAL REQUIREMENTS

CAUTION, FOR PERSONAL SAFETY:

DO NOT USE AN EXTENSION CORD WITH

THIS APPLIANCE.

REMOVE HOUSE FUSE OR OPEN

CIRCUIT BREAKER BEFORE BEGINNING

INSTALLATION.

This appliance must be supplied with the proper

voltage and frequency, and connected to an

individual, properly grounded branch circuit,

protected by a circuit breaker or time delay fuse, as

noted on the rating plate.

Wiring must conform to National Electric Codes.

If the electric service provided does not meet the

above specifications, it is recommended that a

licensed electrician install an approved outlet.

Because range terminals are not accessible after

range is in position, flexible service conduit or cord

must be used.

Anti-Tip Bracket

(install in either rear corner)

INSTALLATION INSTRUCTIONS

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

GE JBC17 Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JBC17