GE JGBP75 Manuel d'utilisateur télécharger pdf (Page 42)

To determine if the bottom burner flames are

burning properly, remove the oven bottom.

Flames should have approximately 1² blue cones

and, if range is supplied with natural gas, should

burn with no yellow tipping. (With most LP gas,

small yellow tips at the end of outer cones are

normal.) Flames should not lift off burner ports.

If lifting is observed, gradually reduce air shutter

opening until flames are stabilized.

To remove the oven

bottom:

1. Remove the

knurled screws

holding down rear

of the oven bottom.

2. Grasp the oven

bottom at finger slots

on each side.

3. Lift the rear of the oven bottom enough to

clear the lip of the range frame, then pull out.

ADJUST BROIL AND OVEN BURNER AIR

ADJUSTMENT SHUTTERS IF NECESSARY

Air adjustment shutters for the top and bottom

burners regulate the flow of air to the flames.

The air adjustment shutter for the top

(broil) burner is in the center of the rear

wall of the oven.

The shutter for the bottom (oven) burner is near

the back wall behind the storage drawer or the

kick panel (depending on the model). Remove

the drawer or panel. See the Care and Cleaning

section in this guide.

To adjust the flow of air to either burner, loosen

the Phillips head screw and rotate the shutter

toward open or closed position as needed.

The flames for the top (broil) burner should be

steady with approximately 1² blue cones and should

not extend out over the edges of the burner baffle.

INSTALLATION INSTRUCTIONS

(continued)

LEVELING THE RANGE

1. Remove the storage

drawer or kick panel.

2. Use a 3/16² open-end

or socket wrench to back

out both rear leveling legs

approximately two turns.

3. Use a 1

⁄

² open-end or

adjustable wrench to back

out the front leveling legs

two turns.

4. Install the oven shelves

in the oven and position

the range where it will be

installed.

5. Check for levelness by placing a spirit level or

a cup, partially filled with water, on one of the

oven shelves. If using a spirit level, take two

readings—with the level placed diagonally first

in one direction and then the other.

6. Adjust the leveling legs until the range is level.

7. After the range is level, slide the range

away from the wall so that the Anti-Tip device

can be installed.

Air adjustment

shutter

Loosen

Air adjustment

shutter

Oven bottom

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Commentaires sur ces manuels

Pas de commentaire

GE JGBP75 Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JGBP75