GE JGRP20 Manuel d'utilisateur Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
25
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting Tips
Care and cleaning of the oven. www.GEAppliances.com
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
Broiler Pan and Grid
After broiling, remove the broiler pan from
the oven. Remove the grid from the pan.
Carefully pour out grease from the pan into
a proper container. Wash and rinse the
broiler pan and grid in hot water with a
soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with wet
paper towels or a dishcloth. Soaking the
pan will remove burned-on foods.
The broiler pan and grid may be cleaned
with a commercial oven cleaner.
Both the broiler pan and grid can also be
cleaned in a dishwasher.
Do not store a soiled broiler pan and grid
anywhere in the oven.
CAUTION: Do not clean the broiler pan or grid in a
self-cleaning oven.
Grid
Pan
Removable Storage Drawer
The storage drawer is a good place to store
cookware and bakeware. Do not store
plastics and flammable material in the
drawer.
Do not overload the storage drawer. If the
drawer is too heavy, it may slip off the track
when opened. To open the drawer, grasp
the center of the handle and pull straight
out.
Most cleaning can be done with the drawer
in place. However, the drawer may be
removed if further cleaning is needed. Use
soap and warm water to thoroughly clean.
To remove:
Pull the drawer straight out and lift over
the guide stops.
To replace:
Lift over the guide stops and slide the
drawer into place.
To clean both the inside and the outside:
Wipe with soap and water. Rinse well.
Do not use cleansing powders or harsh
abrasives which may scratch the surface.
Oven Air Vents
Never block the vents (air openings) of the
oven. They provide the air inlet and outlet
that are necessary for the oven to operate
properly with correct combustion.
Air openings are located under the control
panel, above the door.
How to Remove Packaging Tape
To remove the adhesive residue left from
packaging tape, use household dishwashing
liquid, mineral oil or cooking oil. With a
soft cloth, rub into the area and allow to
soak. Rinse and dry well. Repeat procedure
using an appliance polish to insure no
damage is done to the oven. Packaging tape
can be found in the following areas:
Control Panel Area, Door Handle, Door
Trim and Oven Area.
NOTE: This should be done before the oven is
turned on for the first time. The tape cannot be
removed once the oven has heated.
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Commentaires sur ces manuels

Pas de commentaire