GE JGSP20 P Manuel d'utilisateur télécharger pdf (Page 28)

Anti-Tip Device Installation Instructions

for Kit No. 045 (344119)

WARNING

● ALL RANGES CAN TIP

●

INJURY COULD RESULT

● INSTALL ANTI-TIP

DEVICE PACKED

WITH RANGE

● SEE INSTRUCTIONS

1.

Before placing range in the

counter, notice the location of the

stability bracket which is already

attached to the back of the

range.

\

Long Screw

/

Bracket

\

\

2.

Fasten one end of the stability

4. Place the range in the counter

chain to the floor or the wall with

the long screw and washer supplied.

Make certain the screw is going

This location should work for-most

into the wall

ulate

at the base of the

installations. However, it maybe

more convenient to hook the

stability chain

to

the unit when the

stability bracket is attached to the

upper set of holes in the back of the

range (see Fig. 2).

Make sure there are no structural

supports for the countertop that

will interfere with the stability

bracket when located in the upper

set of holes. Determine where the

gas plumbing is located behind the

range so the chain and bracket will

in no way damage the plumbing.

wall or one

o~the studs in the wall

(see Fig. 1). Whether you attach the

chain to the wall or floor, be certain

that the screw is in at least 3/4”

thickness of wood other than

baseboard and that there are no

electrical wires or plumbing in the

area that the screw could penetrate.

Attach the stability chain in a

location that will allow it to be in

line with the bracket side-to-side as

much as possible when attached to

the unit. Test to see if the chain is

securely fastened by tugging on it.

3. Temporarily attach the loose end

of the chain to the rear of the

countertop with the tape from the

packaging (see Fig. 1).

cutout leaving just enough room

between the back of the range and

the wall to reach the stability

bracket.

5. Hook the loose end of the chain

onto the bracket by slipping the

nearest link of the chain into the

slot in the bracket (see Fig. 2),

making sure the chain is pulled as

tight as possible and that there is no

excess slack in the chain after chain

is attached to the bracket.

Excess slack in the chain could

allow the range to tip over

excessively.

6.

Slide the range all the way back

into the counter cutout. Once the

range is pushed back in

dace.

there

will be a small amount

df

slack in

the chain. This is normal.

28

1 2 ... 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire