GE PGS950EEFES Guide d'installation télécharger pdf (Page 24)

49-85213-1

Maintenance

CARE AND CLEANING: Maintenance

SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical

power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in

electric shock or burn.

WARNING

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot

glass with bare hands or a damp cloth can cause burns.

CAUTION

Oven Light Replacement

Oven Light Bulb

NOTE: The glass cover should be removed only when

cold. Wearing latex gloves may offer a better grip.

Before replacing the bulb, disconnect electrical power to

the oven at the main fuse or circuit breaker panel. Let

the bulb cool completely before removing it. For your

safety do not touch a hot bulb with a damp cloth. If you

do the bulb may break.

To remove:

Turn the glass cover counterclockwise 1/4 turn until the

tabs of the glass cover clear the grooves of the socket.

Remove the bulb.

To replace:

Put in a new 40-watt appliance bulb. Place the tabs of

the glass cover into the grooves of the socket. Turn the

glass cover clockwise 1/4 turn.

NOTE:

■ A 40-watt appliance bulb

is smaller than a standard

40-watt household bulb.

■ Reconnect electrical power

to the oven once the new

bulb is installed.

■ For improved lighting inside

the oven, clean the glass

cover frequently using a

wet cloth. This should be

done when the oven is

completely cool.

Bulb

Socket

Tab

ø2”

Max

length

Glass cover

Lift-Off Lower Oven Door

The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.

To Remove the Door:

1. Fully open the door.

2. Pull the hinge locks up and away from the range

frame to the unlocked position.

3. Firmly grasp both sides of the door near the top.

4. Close door until the top of the door is approximately

6” from the range frame.

5. Lift door up and away from the range until both hinge

arms are clear of the slots in the range frame.

To Replace the Door:

1. Firmly grasp both sides of the door near the top.

2. With the door at the same angle as the removal

position, rest the notch on the underside of the left

hinge arm on the bottom edge of the left hinge slot.

The notch in the hinge arm must be fully seated into

the bottom of the slot. Repeat for the right side.

3. Fully open the door. If the door will not fully open, the

notches in the bottoms of the hinge arms have not

seated correctly in the bottom edge of the slot. Lift the

door off the range and repeat previous step.

4. Push the hinge locks toward the range cavity and

down to the locked position.

5. Close the oven door.

Removal positionPull hinge locks up to unlock

Push hinge locks down to lockRest notch on bottom edge

of hinge slot

Notch

Bottom

edge of

slot

Hinge arm

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

GE PGS950EEFES Guide d'installation Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE PGS950EEFES