GE ADW! 000 SERIES Manuel d'utilisateur télécharger pdf (Page 8)

Operation of electronic models (model GSD4000 Only)

Using the Dishwasher Door

door must be closed and locked into place to select a LOAD SELECTIONor an OPTION.

Ifthe door is openedduring a cgcleand left open,the dishwasherwill beeponce every30 secondsuntil the

door is cosed and arched into p ace.

Start

Close and latch the doon Touch the START/RESET pad to begin the cycle. Water fill begins and

approximately 60 seconds later the wash action begins.

NOTE:The dishwasher remembers your last cgcle so you don't have to reprogram each time. When

the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON

and displag the last settings you selected.

If you don't want to change ang of the settings, simply touch the START/RESETpad to begin

the cycle.

Also, if a power failure occurs, NORMAL and HEATEDDRYwill automatically be programmed.

Hake any new selections and touch the START/RESETpad to begin the cycle.

Clean

This light is illuminated when a wash cgcle is complete. The light will stag ON until the door is opened.

Flashing Displag Lights

Lights What It Means What To Do

This is normal. Allow the dishwasher to drain and reset before you start a new

The START/RESET pad wash cycle.

has been pressed.

Control Error

CLEAN

Pressthe START/RESETpad to turn off the beeper If the CLEAN

light continues to flash, call for service.

PLUS A

BEEPING

SOUND

Asj

PLUS A

BEEPING

SOUND

Control Error

Pressthe START/RESETpod to turn off the beeper and the

dishwasher will attempt to reset. Restartthe wash cgcle.

If this error continues,turn off the power to the dishwasher at

the circuit breaker for 30 seconds.Try the dishwasher again.

If the error is still present, call for service.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

GE ADW! 000 SERIES Manuel d'utilisateur Page 8