GE GDT226SSLSS Manuel du propriétaire télécharger pdf (Page 6)

6 49-55124-1

Getting started

USING THE DISHWASHER

Start Dishwasher

Start Press the Start pad and close the door within 4 seconds to start the cycle or begin the Delay

Start countdown. The Start light will turn on. The wash cycle will begin after 10 seconds and

then pump out for 60 seconds prior to filling the dishwasher with water. To activate the display,

press any pad with the door open.

Interrupt

or Pause

To interrupt or pause a cycle, slowly open the door. Opening the door will cause the wash cycle

to pause. The dishwasher will beep every minute to remind you to close the door. To restart or

resume the cycle, press Start, and close the door within 4 seconds. If the door is not closed within

4 seconds, the Start light will start blinking and the dishwasher will beep once every minute to

signal that the cycle did not restart. If the Start light is blinking, the dishwasher is waiting for input.

Cancel To cancel a wash cycle, press and hold the Start pad for 3 seconds and close door.

The dishwasher w

ill drain, emit a beep sound, and the wash cycle light will turn off.

Indicator Lights

Sanitized Displayed at end of the cycle when Wash Temp - Sanitize has been selected and dishwasher

has met requirements for sanitization. See Wash Temp - Sanitize, for complete description.

Opening the door will turn off the light.

Clean Displayed when a wash cycle is complete. The light stays on as a reminder that the dishes are

clean. Opening the door will turn the light off.

Display

Time

Remaining

During operation, the display shows the total number of minutes remaining in the cycle. During a

delay start, the display will show hours of time remaining until the cycle starts.

Check the Water Temperature

The entering water should be at least 120°F (49°C) and

not more than 150°F (66°C) for effective cleaning and to

prevent dish damage. Check the water temperature with a

candy or meat thermometer.

Turn on the hot water faucet nearest the dishwasher,

place the thermometer in a glass and let the water run

continuously into the glass until the temperature stops

rising.

Use a Rinse Agent

Rinse agents, such as Finish

Jet-Dry

Rinse Aid are designed for great drying action and to protect against spots

and film build-up on your dishes, glasses, flatware, cookware, and plastic.

Filling the Rinse Agent Dispenser

The rinse agent dispenser holds 3.9 oz. (115 ml) of rinse agent. Under normal conditions, this will last approximately

one month.

Make sure the dishwasher door is fully open.

Open the dispenser door. (Rinse agent compartment is on the right side of

dispenser.)

Slowly add rinse agent until the cup is full. You may need to pause several times to

allow rinse aid to settle.

Clean up any spilled rinse agent with a damp cloth to prevent foam from forming

inside the dishwasher.

Close the dispenser door.

Dispensers

To turn this option ON/OFF, press and hold the Start and Wash Temp buttons for 5 seconds, close the door and wait 3

minutes for the dishwasher to go into sleep mode. In the OFF mode, the control display, control sounds, and interior lights

(on some models) will not respond to the door opening/closing. This mode can be used when observing certain religious

holidays such as the Sabbath. To activate the control and interior lights (on some models), press any button.

Sabbath/Door Wake Up Mode

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE GDT226SSLSS Manuel du propriétaire Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE GDT226SSLSS