GE GDT635HSMSS Manuel d'installation télécharger pdf (Page 6)

Toekick

Remove 2

Toekick Screws

REMOVE TOEKICK

Skip this step if the toekick is not pre-

installed on the unit. On some models the

toekick is packaged separately with the unit.

• Remove the 2 toekick screws and toekick. Set aside

for use in Step 21.

STEP 1

PREPARATION

Locate the items in the installation package:

• Screws

• Junction box cover

• Drain hose and clamp

• Mounting brackets

• Trim pieces (on some models)

• Drain hose hanger

• Insulation pieces (some models)

• Toekick (pre-installed on some models)

• Owner’s Manual

• Product samples and/or coupons

Dishwasher Installation

STEP 3

REMOVE WOOD BASE,

INSTALL LEVELING LEGS

IMPORTANT – Do not kick off wood base!

Damage will occur.

• Move the dishwasher close to the installation location

and lay it on its back. NOTE: Do not place the

dishwasher on its side.

• Remove the 4 leveling legs on the underside of the

wood base with a 15/16” socket wrench.

• Discard base.

• Screw leveling legs back into the dishwasher frame,

approximately 1/2” from frame as shown.

CHECK DOOR BALANCE

• With dishwasher

on the wood

base, check the

door balance

by opening and

closing the door.

• Door is properly

balanced if, when

opened, it self

closes within 20°

from vertical,

stays in position

from 20° to 70°

and falls fully

open beyond 70°.

• If necessary increase or decrease tension as shown.

Latch door and adjust both springs to the same

tension setting to correct balance.

Tip: Make sure door opens and closes smoothly.

Check door opening and closing. If door does not open

easily or falls too quickly, check spring cable routing.

The cable is held in place by “shoulders” on the pulley.

Check to be sure cable has not slipped over the pulley

shoulders and is routed as shown.

Approx

1/2"

STEP 4

Door

closes

within

20°

Door stays in

position from

20° to 70°

Door falls fully

open beyond 70°

Side View

STEP 2

Increase

Tension

Decrease

Tension

Side View

Make sure

pulley cable

is within

pulley

shoulders

Front View

Do not remove wood base until you are ready to

install the dishwasher. The dishwasher will tip over

when the door is opened if base is removed.

CAUTION

No quite la base de madera hasta que esté listo

para instalar el lavaplatos. Si se quita la base, el

lavaplatos se volcará cuando se abra la puerta.

PRECAUCIÓN

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

GE GDT635HSMSS Manuel d'installation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE GDT635HSMSS