Ge GLDT690DWW Manuel d'utilisateur télécharger pdf (Page 3)

Installation Preparation

Figure 1

Cabinets

Square

and

Plumb

Floor MUST

be Even with

Room Floor.

Plumbing and Electric Service

Must Enter Shaded Area

32-1/2" to 35"

Underside of

Countertop

to Floor

24"

Min.

Min

24ą

PREPARE DISHWASHER ENCLOSURE

Figure

Clearance for Door

Opening 2"Minimum

Countertop

Dishwasher

25-5/8"

• The rough cabinet opening must be at least 24”deep and 23-

5/8”To 24” Wide. The opening should beto 35”max. height.

• The dishwasher must be installed so that drain hose is

no more than 10feet in length for proper drainage.

• The dishwasher must be fully enclosed on the top,

CLEARANCES: When

installed into a corner,

allow 2” min. clearance

between dishwasher and

adjacent cabinet, wall or

other appliances. Allow

25-5/8” min. clearance

from the front of the

dishwasher for door

opening. Figure 2

DRAIN REQUIREMENTS

Follow local codes and ordinances.

• Do not exceed 10 feet distance to drain.

• Do not connect drain lines from other devices

to the dishwasher drain hose.

• Dishwasher must be connected to waste line with an

air gap (not supplied) or 32” minimum high drain loop,

depending on local codes and ordinances to prevent

back flow into the dishwasher .

• Air gap must be used if waste tee or disposer connection

is less than 18”above the floor to prevent siphoning.

DRAIN PREPARATION

The type of drain installation depends on answers to

the following questions:

 Do local codes or ordinances require an air gap?

 Will waste tee or disposer connection be less than

18”above the floor?

 Will installation have a drain loop less than 32”

above floor?

If the answer to ANY of the 3 questions above is YES,

Method 1 MUST be used. Otherwise either Method 1

or Method 2 may be used. Figure 3 or Figure 4.

CAUTION:

An air gap MUST BE USED if the drain hose is connected

to waste tee or disposer lower than 18”above the floor.

Failure to provide the proper drain connection height

with air gap or 32” minimum, high drain loop will result

in improper draining of the dishwasher.

PRECAUCIÓN:

DEBE USARSE un espacio de aire si la manguera de drenaje

se encuentra conectada a una T de eliminación o desecho

inferior a 18” sobre el piso. No brindar la adecuada altura

de conexión de drenaje con un espacio de aire o un circuito

de desagüe de 32” como mínimo, provocará un drenaje

inadecuado del lavaplatos.

Figure 3

Method 1 Air Gap with Waste Te e or Disposer

Figure 4

18"

Min.

32"

Min.

32"

Min.

18"

Min.

Method 2 High Drain with Waste Tee or Disposer

Provide a method t o attach drain hose to unde r s i d e

of countertop.

18"

Min.

Install waste tee or disposer and air gap according to

Manufacturer s instructions.

CABINET PREPARATION

• Drill a 1-1/2” dia. hole in the cabinet wall within the shaded

areas shown in Figure 1 for the drain hose connection. The

hole should be smooth with no sharp edges.

1 2 3 4 5 6 7 8 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ge GLDT690DWW Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Ge GLDT690DWW