GE PDT720SGHWW Manuel d'instructions télécharger pdf (Page 5)

PREPARE HOT WATER LINE

NOTE: GE recommends copper tubing for the water line, but if

\RXFKRRVHWRXVHÀH[LEOHKRVHXVH*(·VWX28X326ÀH[LEOH

braided hose.

• The water supply line (3/8” copper tubing or flexible braided

hose) may enter from either side, rear or floor within the

shaded area shown in Figure F.

• The water supply line may pass through the same hole as the

electrical cable and drain hose. Or, cut an additional 1-1/2"

diameter hole to accommodate the water line. If power cord

with plug is used, water line must not pass through power

cord hole.

Figure F

Water Line Connection

• If using a flexible braided supply hose, label the hose with the

installation date to use as reference. Flexible braided hoses,

elbows and gaskets should be replaced in 5 years.

• Turn off the water supply.

• Install a hand shut-off valve in an accessible location, such

as under the sink. (Optional, but strongly recommended and

may be required by local codes.)

• Water connection is on the left side of the dishwasher. Install

the hot water inlet line, using no less than 3/8" copper tubing

or a flexible braided hose. Route the line as shown in Figure F

and extend forward at least 19" from rear wall.

$GMXVWZDWHUKHDWHUIRU)WR)WHPSHUDWXUH

• Flush water line to clean out debris.

• The hot water supply line pressure must be 20-120 PSI.

Turn page to begin dishwasher installation.

Cabinet Face

Shut-off

Valve

2" From Floor

19" From Wall

From

Cabinet

1-1/2" Dia.

Hole

Hot

Installation Preparation

CAUTION:

Do not remove wood base until you are ready to install the

dishwasher. The dishwasher will tip over when the door is

opened if base is removed.

1 2 3 4 5 6 7 8 9 10 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE PDT720SGHWW Manuel d'instructions Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE PDT720SGHWW