GE PDW8900 Series Manuel d'utilisateur télécharger pdf (Page 7)

Consumer Support

Troubleshooting TipsOperating InstructionsSafety Instructions

Flashing display lights.

Status Indicator Lights What It Means

START/RESET Cycle has been interrupted by pressing the START/RESET pad. Light will quit

flashing after the dishwasher automatically drains out the water.

Recommended dishwasher products.

GE recommends the following products for use in its

dishwashers:

■ For your Manual Washer Dispenser, Cascade

and Electrasol

powder, liquid or gel automatic

dishwasher detergents are approved.

■ For your SmartDispense Detergent Dispenser, use

only the recommended detergents listed on page

10 of this manual.

■ Jet Dry

and Cascade Crystal Clear

to remove

spots and prevent new film buildup on your dishes,

glasses, flatware, cookware and plastic.

■ Cascade

Plastic Booster

™

to remove red staining

inside your dishwasher that can come from some

tomato-based stains.

■ Only use liquid or gel automatic dishwasher

detergent in the SmartDispense.

■ Cerama Bryte

Stainless Steel Appliance Cleaner

to clean the stainless steel panel of GE and Profile

™

stainless exterior dishwashers.

■ Jet Dry

Dishwasher Cleaner to help remove

some hard water mineral stains that can occur

in hard water conditions.

Clean

PDW8900 Series

The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will

stay ON until a pad is pressed or the door is opened and then closed.

PDW9700 and PDW9900 Series

The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements

are complete. You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30

minutes to 4 hours (depending on selected cycle) after the CLEAN light is illuminated to continue drying

the dishes. The fan can be turned off by opening the door and pressing any keypad.

NOTE: To turn off the audible end-of-cycle signal (or re-activate it if it was previously disengaged), press

the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep

option has been toggled.

NOTE: If you are not using the SmartDispense and you want to turn the LOW DETERGENT LED light off,

press the ADDED HEAT pad 5 times within 3 seconds. You will hear three beeps, then the light will go off.

You can turn the light back on by pressing the ADDED HEAT pad 5 times within 3 seconds.

ge.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE PDW8900 Series Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE PDW8900 Series